Need a little help, I bought a unit but it's locked the Bluetooth to the phone and music streaming so I can't pair it to my OBD bluetooth dongle.
Other issue are the crap built in eq for sound control for the Audi bose system. Ran poweramp to get better music control and the eq in that sorted my music quality issue but it plays music at a low volume so when you switch to radio all he'll goes on due to the massive difference in volume levels.
so any help or suggestions would be great
I believe that PowerAmp has its own volume and balance controls that are independent from the unit's "generic" controls. What I recomend you do is set the unit's EQ to flat and use the PowerAmp to set the EQ the way you want. For the volume it would be the other way around; leave PowereAmp at max volume and use the system's volume to control it.
As for the bluetooth issue, how do you know it's "locked" for phone and music? It may say that on when you pait your phone, but that's only because that's what your phone supports but it doesn't mean you can't pair an OBDII device. In fact, I have that same hting on my phone but I'm still able to pair with my OBDII at the same time.
Are you using a custom ROM or are you still stock? I believe some people have had problems with some OBDII devices which are corrected with an Xposed module (I never had any problems so I don't have much more info).
docurley said:
Need a little help, I bought a unit but it's locked the Bluetooth to the phone and music streaming so I can't pair it to my OBD bluetooth dongle.
Other issue are the crap built in eq for sound control for the Audi bose system. Ran poweramp to get better music control and the eq in that sorted my music quality issue but it plays music at a low volume so when you switch to radio all he'll goes on due to the massive difference in volume levels.
so any help or suggestions would be great
Click to expand...
Click to collapse
I am curious what unit you purchased. I purchased an Audiosources unit for my A3 and after the initial test fit, I have no sound. I unhooked the unit and ran some wiring and now no sound from the radio, stored music, streaming, Bluetooth or even video. Everything powers up and seems to work though. I have not tried to pair a second device yet so I cannot help with that issue. When the sound did work, I did have the low rear volume issue that you appear to of had as well. Thanks.
When I hooked mine up as I have full Bose there was zero sound, I had to use a hi/lo converter which did the trick. The low sound I nailed down to the crap built in eq as I downloaded a great app that overrides it for everything bar the radio for some reason (app viper4android). My unit is going back due to a faulty volume knob, I will be ordering a different unit from some other supplier.
Thanks for the info. I have Bose as well. Can I ask what year and model your Audi is and the brand of the unit you returned and the new one you are considering?
Related
I'm considering putting a new stero in the car but if I do I want to get one with bluetooth that will work with my XV6800. Does anyone out there have one that they are happy with? Handsfree dialing, access to contacts and streaming MP3s to the stereo would all be nice features to have.
Try Sony radios?
Me and my wife have the Sony BT2600 each. Reasonably priced below 200 and will bluetooth phone and stream audio as well (she has the Instinct and I have the htc 6800). You can't upload contacts to the radio but it will use the voice tags stored on your phone. The radio has a built in mic with abilty to adjust mic level from low to high. I love when I stream mp3's/listen to radio stations, the radio cuts to the phone and then resumes when u hang up. The phone's ringtone doesn't play through the speakers. Instead, a series of beeps play through the speakers alerting you to the call.
My wife's phone/audio connects to the radio automatically when her stereo is on. Mine, however, will connect the phone automatically, but I have to manually connect the bluetoothed audio. Not a problem though, all I have to do is press button 6 on the stereo and it will automatically connect the last device. For a budget stereo, I don't know what I'd do without it : )
Best Buy does have some Bluetooth stereos (that's where I got ours) but beware. Some stereos are bluetooth ready and need an adapter/accessory to bring bluetooth functionality to the stereo.
I had read a few reviews of the Sony units where people say that people they are talking to through the stereo couldn't hear them well. Some of them thought it was because of the placement of the microphone on the stereo. Do you not have any issues talking to people through yours?
iam having the worst ever audio quality over bluetooth while listening to songs...whenever there's treble it sounds like a worst radio quality..iam using sony ericsson MW600 bluetooth stereo headset..does someone have a solution for this? or is this universal problem?
smackdownn said:
iam having the worst ever audio quality over bluetooth while listening to songs...whenever there's treble it sounds like a worst radio quality..iam using sony ericsson MW600 bluetooth stereo headset..does someone have a solution for this? or is this universal problem?
Click to expand...
Click to collapse
That sounds like it's using the hands free profile instead of A2DP. You could try going to the options of your bluetooth headset on and untick the "Phone" box, and make sure "Media" is ticked.
I have generally decent bluetooth audio using Motorola T505 to broadcast FM to the car radio (must get around to buying a proper BT head unit, or a new car with one built in...). Most of the problems I have are interference with the FM signal rather than dodgy bluetooth.
However, I do see this kind of bad distortion on the high end with certain pieces of music - generally the solution is to turn down the volume on the Note a couple of notches and crank it up on the car stereo. I assume some of my tunes are just recorded/ripped REALLY DAMNED LOUD, it seems to mainly be things I ripped myself years ago so I probably didn't pay much attention to the levels at the time.
If you lower the volume from the Note does the distortion disappear?
Barkotron said:
I have generally decent bluetooth audio using Motorola T505 to broadcast FM to the car radio (must get around to buying a proper BT head unit, or a new car with one built in...). Most of the problems I have are interference with the FM signal rather than dodgy bluetooth.
However, I do see this kind of bad distortion on the high end with certain pieces of music - generally the solution is to turn down the volume on the Note a couple of notches and crank it up on the car stereo. I assume some of my tunes are just recorded/ripped REALLY DAMNED LOUD, it seems to mainly be things I ripped myself years ago so I probably didn't pay much attention to the levels at the time.
If you lower the volume from the Note does the distortion disappear?
Click to expand...
Click to collapse
No, still there. I'm using Galaxy note and noticed a similar problem, both with a pair of Plantronics BackBeat and bluetooth car kit FM transmitter. It sounds pretty fine on my Archos 5IT that is running Android 1.6 and my Nokia N900 running Maemo. My note is currently running on Android 2.3.6 Rocket 12.
Bluetooth stereo sounds great for me using Sennheiser MM-200...
If you have exceptionally bad audio quality, it's probable that the headset is being used in handsfree audio mode, and not media mode. If you go to settings>bluetooth, and click on your device, you should see which modes are ticked.
Also, some people have reported better bluetooth audio quality with the LR1 modem. See here:
http://forum.xda-developers.com/showthread.php?t=1663810&highlight=bluetooth
Hi All,
I need some help getting my Sabre 9018 USB DAC to work with the Joying Headunit.
I have recently purchased a Joying 7" 5.1.1 headunit. The sound quality of this unit is terrible, and after hearing the 9018 DAC connected to my phone, I simply cannot go back to the Joying sound. I'm quite good at troubleshooting/mods for Android but not an expert at all.
I've managed to get sound out of the DAC when using HibyMusic player installed on the Joying without Volume control. Spotify/Poweramp/android music player simply do not work.
My Samsung s5 using Xstrolite rom played everything flawlessly through the DAC plug and play.
I've reviewed some threads regarding DAC support but nothing really helps with the 5.1.1 units. Hence why I need help from you guys,
Thanks in advance
Daniel
the "workaround" for this is to get an external DSP, and then use the remote control of the DSP to control the volume.
Several of us here use the C-DSP 6x8 and it works well. It also includes SPDIF in, so you can go full digital all the way to the DSP. It is not a cheap solution, but if you can manage to find a good deal on a used one, it will allow you to control volume in the apps that have a dedicated USB driver. For non-critical listening, you can use your normal joying pre-outs, so you effectively get a fully functional system without having to heavily modify the HU system files.
Also there is a cheaper DSP available from minidisp called the 2x4, and you can connect an external potentiometer to control the volume. This would be the cheapest method of doing what I described above, and you still get the huge benefit of able to EQ your system with a real DSP.
Okay, thanks for the feedback. So even using neutron player, you still can't control the volume? I would try this, but Im away for work atm. Thanks again
Inside the app, yes, by attenuating the output. But you still get no sound outside of apps without a USB driver. That's why I like the dsp option. If sq is high priority it's the optimal choice regardless. Especially if you get one with digital in like the cdsp 6x8.
Do you hear FM radio and Bluetooth sound through USB ?
Hi Guys
I have been searching and researching for hours but can't get this to work the way that I want, although I don't see any reason why it shouldn't work.
I recently purchased one of my dream cars, and promptly changed the headunit to a more modern unit, to allow me to have spotify, google maps, etc etc. I purchased the Eonon GA8150A for this purpose, and it sounds OK.
I was always planning to upgrade the sound, namely using a Helix DSP and amplifier, upgrading the speakers, etc etc.
Since the helix has an optical input, I figured I could maximise quality by running a digital signal to the unit - to this end I purchased a Behringer UCA202, as its a class compliant USB DAC which has optical out.
I connected via USB, and went into developer settings, and changed the "Select USB Configuration" to Audio. I plugged in some headphones for testing, and....nothing.
After some research, I downloaded the Onkyo player, and this worked! I was getting audio via my USB dac, through the headphones. But spotify, bluetooth, radio, nothing else worked.
Was wondering if what I am trying to achieve is possible?
The only other alternative it to sell the uni, and purchase an AVIN Avant 3 unit - this comes with high quality 4V pre outs but its a lot more expensive and i really dont want to do this. I could use the RCA outs on the Eonon to feed the processor, but as mentioned, these leads to many stages of A/D D/A conversion that will markedly reduce quality.
Thanks
Saad
Ok updates - it now works - the inbuilt audio player via USB, spotify, both work, however the radio doesn't send audio via the DAC, and nor does it send audio to the dac from my phone via bluetooth.
Not sure why this works now, maybe I had to turn off the car a while so the unit could properly reset?
The head unit volume control however doesn't work to adjust the volume of the audio coming from the dac.
Any way to get radio and bluetooth working via the dac?
Cheers
So the main problem with the chinese brands is the lack of output quality especially the subwoofer output, i always wonder if you could do this and couldnt find any info about it, well today im happy to report, you can, in my case my car allow me to have two headunits, and i get to keep my volume knob, but i guess is possible to also connect the unit to a amplifier with bluetooth.