Hello guys i am facing a problem with my samsung galaxy s4 i9500
My phone was always on stock frimware never rooted nothing wrong done with it
When lollipop came out in india (5.0.1) i decided to update it
When i updated it my phone downloaded a 4.3 version update first and when i installed the update it stucks on samsung logo and nothing else happens
I tried to factory reset by going into recovery using vol.up+home+power button but it does not open recovery screen rather the update begins to get install again and when it completes it shows error and device re boots and gets stuck again at samsung logo
Please tell me what to do
I am a complete noob so please try to be as brief as possible
Looking forward for everyone's help
Well, the only option I see is to flash stock rom via Odin.
You can probably get the latest firmware for your device from sammobile.
Here is a guide you can follow. Just skip the unrooting steps and go directly to the flashing of the official firmware.
GDReaper said:
Well, the only option I see is to flash stock rom via Odin.
You can probably get the latest firmware for your device from sammobile.
Here is a guide you can follow. Just skip the unrooting steps and go directly to the flashing of the official firmware.
Click to expand...
Click to collapse
Thanx for help buddy
Related
I have rooted my Samsung Note 3 with a custom rom running Jellybean 4.3 with clockwork mod recovery. I have tripped knox due to rooting it. When Kitkat came out March 17th 2014, I wanted to upgrade and go back to official firmware with Kitkat to try it out. Since I have rooted my phone to run viper4android audio kernel I am unable to do an official OTA or Kies update. That said I went about downloading the new Bell Canada Note 3 firmware 4.4.2. I was told to flash a Jellybean Bell Firmware first before flashing the Kitkat version to avoid boot loops or other problems. Trying to do so with Odin in download mode ended in failure just trying to flash jellybean stock. Didnt get that far really. It showed a fail in the Note 3 screen to this effect in read this message (sw rev check fail : sbl1 fused 2 binary 1) . Odin didnt load like I am usually use to seeing by unzipping the firmware into a folder and adding it to the PDA field. After I loaded the .tar file (md5) file into pda it checked it and then told me its finished successfully but the next line it said CS Fail. After hitting start it said fail instantly in the odin window and on the Note 3 I did see a bar showing me the progress of install for 1 second until odin told me of the fail. Now my Note is in download mode and can't get past this problem to get it running again! Please any help would be greatfull to getting me past this problem and onto Kitkat or even back to Jellybean. Any other questions you may have I will supply you the info.
Thanks
Nervous Android user!
weston109 said:
I have rooted my Samsung Note 3 with a custom rom running Jellybean 4.3 with clockwork mod recovery. I have tripped knox due to rooting it. When Kitkat came out March 17th 2014, I wanted to upgrade and go back to official firmware with Kitkat to try it out. Since I have rooted my phone to run viper4android audio kernel I am unable to do an official OTA or Kies update. That said I went about downloading the new Bell Canada Note 3 firmware 4.4.2. I was told to flash a Jellybean Bell Firmware first before flashing the Kitkat version to avoid boot loops or other problems. Trying to do so with Odin in download mode ended in failure just trying to flash jellybean stock. Didnt get that far really. It showed a fail in the Note 3 screen to this effect in read this message (sw rev check fail : sbl1 fused 2 binary 1) . Odin didnt load like I am usually use to seeing by unzipping the firmware into a folder and adding it to the PDA field. After I loaded the .tar file (md5) file into pda it checked it and then told me its finished successfully but the next line it said CS Fail. After hitting start it said fail instantly in the odin window and on the Note 3 I did see a bar showing me the progress of install for 1 second until odin told me of the fail. Now my Note is in download mode and can't get past this problem to get it running again! Please any help would be greatfull to getting me past this problem and onto Kitkat or even back to Jellybean. Any other questions you may have I will supply you the info.
Thanks
Nervous Android user!
Click to expand...
Click to collapse
you cant flash back to 4.3 when you on 4.4.2 and did you succeed when flashing 4.4.2?
Flashing
hhai2pth said:
you cant flash back to 4.3 when you on 4.4.2 and did you succeed when flashing 4.4.2?
Click to expand...
Click to collapse
I havent been able to do anything. I was on Jellybean 4.3.2 custom rom with a custom recovery and tried to flash it back to a stock version of Jellybean before the update to Kitkat. I didnt get that far to even try flashing Kitkat because flashing Jellybean Canadian stock rom was unsuccessful with the errors I mentioned in my earlier post. Now I am stuck in download mode and unable to flash using odin.
weston109 said:
I havent been able to do anything. I was on Jellybean 4.3.2 custom rom with a custom recovery and tried to flash it back to a stock version of Jellybean before the update to Kitkat. I didnt get that far to even try flashing Kitkat because flashing Jellybean Canadian stock rom was unsuccessful with the errors I mentioned in my earlier post. Now I am stuck in download mode and unable to flash using odin.
Click to expand...
Click to collapse
I think you can power if off by pressing the power button for a few seconds. And then flash a custom recovery, reboot and flash a Kit Kat custom rom via Odin or Custom recovery. Hope it helps.
weston109 said:
I havent been able to do anything. I was on Jellybean 4.3.2 custom rom with a custom recovery and tried to flash it back to a stock version of Jellybean before the update to Kitkat. I didnt get that far to even try flashing Kitkat because flashing Jellybean Canadian stock rom was unsuccessful with the errors I mentioned in my earlier post. Now I am stuck in download mode and unable to flash using odin.
Click to expand...
Click to collapse
Knox was tripped. You said it yourself. Go and read up on Knox.
The answer will be very clear afterwards. It's quite clear to me.
Also, don't take this the wrong way.... but you probably should not have done any of this my friend. Your skill level makes this obvious.
I suggest not getting a Samsung phone next time as Knox is hard to get around (it's possible, I was rooted on 4.3 and I am now on 4.4.2 stock flashed with Odin and Knox is still 0x0).
weston109 said:
I havent been able to do anything. I was on Jellybean 4.3.2 custom rom with a custom recovery and tried to flash it back to a stock version of Jellybean before the update to Kitkat. I didnt get that far to even try flashing Kitkat because flashing Jellybean Canadian stock rom was unsuccessful with the errors I mentioned in my earlier post. Now I am stuck in download mode and unable to flash using odin.
Click to expand...
Click to collapse
what's the CSC of your phone? you should try the one newer vesion of 4.3 cause if it's an older firmware it refused flash
I was able to downgrade the phone to NB1 and root it with Towelroot, and used Safestrap in order to get recovery on the device.
After that, I booted into recovery and installed the GPE 5.0.1 ROM.: http://galaxys4root.com/t-mobile-galaxy-s4-roms/gpe-android-5-0-1-lollipop-rom-for-galaxy-s4/
Now the phone will not go past the S4 splash page, reboots and then goes into the stock recovery. Ive tried factory reset, clearing cache and removing the battery.
Any help is appreciated. I bought this phone for my fiance and am wanting to give it to her soon as a present.
Thank you so much in advance.
I think the problem is that you downgraded.
GDReaper said:
I think the problem is that you downgraded.
Click to expand...
Click to collapse
I couldnt install towelroot on the 4.4.4 version it came with since it said device wasnt supported.
I was following these instructions: http://www.droidviews.com/root-att-galaxy-s4-sgh-i337-android-4-4-4-kitkat-firmware-i337ucufnj4/
It states to downgrade, then root, then go back to the 4.4.4. I thought after the steps I took, I could go straight to a custom ROM.
Thanks
I used CF-Auto-Root to root my device. Since towelroot didn't work for me either.
Maybe the rom did not flash right. Try flashing again.
problem in installing lollipop rom india to samsung i9500
I have installed the newly released lollipop rom to my samsung i9500 through odin. it was successfully flashed but the phone cant restart, it stuck with samsung written on the screen and blue light on...what i should do???
HI Guys,
I flashed the Lollipop 5.0.1 CHN firmware and rooted the phone to install the Google apps, then when the India Firmware came i tried to flash that via Odin, it failed. and bricked the phone, could get into download mode but all firmware i've tried fails.
i tried numerous thing to a point where i can now only get CWM- recovery or TWRP open recovery on the phone, and then it allows me to get back into download mode with swver A3, but Odin still fails almost immediately.
help would be much appreciated
regards
Brendan
Vergil069 said:
HI Guys,
I flashed the Lollipop 5.0.1 CHN firmware and rooted the phone to install the Google apps, then when the India Firmware came i tried to flash that via Odin, it failed. and bricked the phone, could get into download mode but all firmware i've tried fails.
i tried numerous thing to a point where i can now only get CWM- recovery or TWRP open recovery on the phone, and then it allows me to get back into download mode with swver A3, but Odin still fails almost immediately.
help would be much appreciated
regards
Brendan
Click to expand...
Click to collapse
So this means you can into Download Mode which is quite a good thing.
Now what you do is download the particular Kies for S4 from the OEM site and connect it when your phone is in Download or that wierd Yellow Triangle with the sign to connect to PC, and then kies will try to save ur phone.
came accross this http://forum.xda-developers.com/showthread.php?t=2269941
Odin completed success fully, but now phone just hangs just after it askes to select the OS language ps. i used the lollipop india rom with the pit in the mentioned post
install a custom recovery using odin like philztouch and do a full wipe to install new rom
will i need a new PIT file?, after full wipe just Odin and lollipop 5.0.1 as normal?
Hi All, just need a huge help here, a friend of mine has been using a N9005 which was auto restarting, she went online and downloaded this firmware...N900AUCUEOC1_N900AATTEOC1_N900AUCUEOC1_ HOME.tar.md5....2.5GB in size...and flashed it, but the phone is stuck in boot loop even after recovery wiping data and cache, the phone can boot into download mode and is detected by odin, but re flashing the firmware always fails and always boot loops on searching that firmware on google it belongs to the AT&T note 3.....is there a solution for this.....I know my way around flashing if am given instructions...please help
Look for instructions regarding soft brick, you'll just have to reflash via odin.
mjmbirige said:
Hi All, just need a huge help here, a friend of mine has been using a N9005 which was auto restarting, she went online and downloaded this firmware...N900AUCUEOC1_N900AATTEOC1_N900AUCUEOC1_ HOME.tar.md5....2.5GB in size...and flashed it, but the phone is stuck in boot loop even after recovery wiping data and cache, the phone can boot into download mode and is detected by odin, but re flashing the firmware always fails and always boot loops on searching that firmware on google it belongs to the AT&T note 3.....is there a solution for this.....I know my way around flashing if am given instructions...please help
Click to expand...
Click to collapse
Flashing a N900A firmware in one N9005 is SUPER WRONG WRONG WRONG. Give a look here select one firmware good for your device and flash it via ODIN.
Joku1981 said:
Flashing a N900A firmware in one N9005 is SUPER WRONG WRONG WRONG. Give a look here select one firmware good for your device and flash it via ODIN.
Click to expand...
Click to collapse
thank you for the reply, am downloading this one...N9005XXUGPOF3...from Nordic countries...will it remove the AT&T bootloader
So I have a galaxys s5 g900f which i cleared it from a rom i used before and got it back to the original form of it. Got the .tar.md5 file of the official galaxy software from sammobile and installed it with odin. After that I wanted to root my phone again and stick with the official software. I tried to do that by the way I always used to with CF-Auto-Root using Odin once more and after downloading the file my phone was normally rebooting to recovery but it actually got stuck there without doing anything. Tried to flash twrp too but still nothing. The only thing i can flash at the time is the official software. Anyone had this issue before and can help? Thanks in advance
Flash the stock ROM again and get your phone back up and working properly
Then use this guide to root / twrp
http://forum.xda-developers.com/showpost.php?p=64961009&postcount=2