Hi,
Im trying to come back to stock from i9505 which i have flashed to GPE 4.4.2 some time ago.
When I try flash a .tar.md5 file with odin i've got an error:
Code:
<ID:0/004> Get PIT for mapping..
<ID:0/004> There is no PIT partition
After checking re-partition:
Code:
<ID:0/004> Can't open the specified file. (Line: 1992)
Im using I9505XXUFNC4_I9505PRTFNC1_I9505XXUFNC4_HOME.tar.md5 rom.
Anyone got idea how to flash it back to stock?
Do you get the same results with other firmwares? I've seen other thread about NC4 firmware with the same error.
good evening
I am in a bit of tight spot
and before a srew it up (more) I wonder if you could help
I have a SM-G900V which is rooted and I had TWRP working just fine
I tried to flash a rom (project infinity) with aroma which freezed on installing aroma
the developer replied to me that the problem was from TWRP which had a bus and that I should instal CWP
I tried to install CWP on top of TWRP through ODIN and got a failure message
as of now I have neither TWRP or CWP or any rom flashed in mydevice
once I go into recovery mode and try to flash the previous rom that I had through the sdcard it says "footer is wrong signature fail" an reboots and gets stuck with no rom
just tried to reinstall TWRP through ODIN and got the failure message again
with the folowing message:
<ID:0/003> Added!!
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> SetupConnection..
<ID:0/003> Initialzation..
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> recovery.img
<ID:0/003> NAND Write Start!!
<ID:0/003> FAIL! (Auth) <OSM> All threads completed. (succeed 0 / failed 1)
please help
Hey man,
Sounds like you're in a bit of a pickle. Not sure if this would be a bit extreme, but I'd download the stock firmware and flash it through Odin. After that, reflash recovery and retry your rom.
I kind of see flashing back to stock a 'fail safe' in most cases, so it's always handy to have the stock firmware stored somewhere anyway. ?
Sent from my SM-G900I
..
fffft said:
Don't flash anything until someone discerns what went wrong..
being impatient at this point will put you at high risk of bricking or worse.
The phone boots normally up until the footer error?
What is the exact error message that you see?
What version of TWRP did you have?
Any backups? If so, do they include your baseband, EFS & PIT?
16 GB ROM?
Did you have a Verizon ROM when this happened?
Rooted?
.
Click to expand...
Click to collapse
let me start by thank you for your time!
I am a bit new to all this, I have flashed some roms in the past so I am also familiar with some stuff...
The phone doesn't boot it gets stuck like the attached picture, the OS doesn't start.
I don't see any message as it is stuck like I mentioned before, I just saw a message of "FAIL!" in Odin when I tried to install CWM on top of TWRP
my version of TWRP was 2.7.1.0
I had a backup on TWRP but as I dont see TWRP working anymore I dont know if its still available
my phone is 16GB
my SM-G900V is rooted and at the moment I had working perfectly SpeedROM v1 Rev2
if you would like to contact me through chat let me know, and again thank you very much!!
Try this
..
fffft said:
Okay, on the positive side there isn't anything to suggest that your bootloader is corrupt which would make this a lot harder. Probably the failed aroma install just messed your kernel up. But I don't want to recommend messing around with shortcut solutions e.g. just flashing the kernel that may or may not work, but would put you at unnecessary further risk.
The earlier suggestion to flash a full stock image is generally sound advice, but it does not apply to all situations. My questions were basically aimed at getting a sense of whether you have corrupted the bootloader or partitioning which has a bearing on how to best recover your phone.
First, I am assuming that you do not have the Dev (unlocked bootloader) version S5. If you have the Dev edition with the unlocked bootloader, do not proceed with the rest of this post until we discuss that.
On the assumption that you have a regular 16 GB Verizon SM-G900V S5, then I would like to see you Odin flash a full stock S5 Verizon image that has been rooted. Unfortunately I couldn't find anyone who has made and posted a stock rooted Verizon S5 image like that. I don't mean a stock rooted (custom) ROM.. I mean the full stock firmware image, including the bootloader, but rooted.
That's fine. The rooted part would just be a little extra insurance put against theoretical possible snags i.e. Knox issues. So I will suggest that you use Odin to flash a full stock Verizon S5 image, with an explicit partition table. Normally we don't touch the partition information (PIT) in Odin, but in your case we need to.
Download the files below from this thread
Unless you already have the file on your PC
Verizon S5 Retail Tar 4.4.2 NCG baseband and Mar 31 kernel
MD5: 699a949b57c771b00db9f3ed675c7a5e
NCG Pit
MD5: 3dd82f91a02c82e60e0a1f9964fdb5c0
Odin 3.09
MD5: 810ad286967d0a33881fd8181d35959f
You should thank the OP in that thread for collating the files that you need in one place.
Particularly that all important PIT file.
Start Odin and check these three boxes only: Auto reboot, Re-Partition, F. Reset Time
Choose the PIT file in the PIT window. Note that the PIT file needs to be extracted. Do not leave it zipped.
Choose the stock firmware tar.md5 file in the PDA window. The tar.md5 file needs to remain tarred i.e. tar.md5 or .tar
Put your phone into download mode. Ensure that your phone is off, remove the battery for a few seconds if necessary, then press volume down + home + power until you see the android robot screen come up. If it doesn't go into download mode, repeat these steps. And in the very unlikely event that you can't get into the download mode at all, stop and post that information
Connect your phone to your PC, Odin should say that it has detected your phone
Press start and let Odin flash your phone
Basically we are replacing all of the system files and assuring that your partitioning has not been corrupted
When Odin finishes with a success message your phone should be back to normal. Do a normal reboot to confirm
If you did not backup your phone, your user files in the /data partition might still be accessible
Decide if you wish to back them up or not. Do so if you need them. Then do a factory reset from the Settings menu
You will need to re-root and reinstall your apps, etc
If you run into any difficulties:
If the Odin write fails, note the error message and double check that your Odin settings were correct
Do not close Odin. Pull the battery from your phone for ten seconds.
Then replace the battery and go into download mode again (vol down + home + power)
Note whether Odin detects the phone
Then try flashing with Odin again. Note that you are not closing the Odin program if the first flash attempt fails
Odin can be a bit picky and it is not unheard of to have to reset the phone like this and run the session a second time
Odin is also picky about USB cables. If you still continued trouble, try a different USB cable and USB port
Don't despair if anything goes astray. There is almost always an alternate way to go about something.
Let us know your results so that we can (hopefully) celebrate. Or at least regroup.
.
Click to expand...
Click to collapse
you senior member??? pppffffffff
you should OWN this forum!!! thanx a lot for your extended time in this explanation mate, I will proceed and let you know
Agreed. I use a Dell and sometimes I have problems with odin using the front usb. I have to use the read usb and then no problems.
Hi Guys!!
I am back, back with my phone completely restored
A special THANX to fffff for your help!!
..
I have read read read cant find a specific solution ..Ok im on KOT49H I337ucufmld. I was on 4.3 before I have flashed with odin many times at first I got a fail at the start aboot.mbn nand fail ..so I removed that file and it started to install but failed at the end... my knox is set to 01 . my boot loader of course was locked down when I tried to flash another recovery.. so I read and people suggested pit files along with tar so I did that. no firmware Samsung official or otherwise will try to install at all with the aboot.mbn intact within the tar . ive flashed and flashed ..everything... so then I got a 32 gb pit file and did a nand erase in odin...and I noticed that by doing that I have my stock recovery back . I then re flashed the proper 16gb pit file and it remained working..so now I have download mode and stock recovery both working but have NO SYSTEM at all installed and cant seem to install one....I need good solid advise..is it a paper weight or is ther a way to zip or tar back either by odin or stock recovery.. help please.
walkerlaney said:
I have read read read cant find a specific solution ..Ok im on KOT49H I337ucufmld. I was on 4.3 before I have flashed with odin many times at first I got a fail at the start aboot.mbn nand fail ..so I removed that file and it started to install but failed at the end... my knox is set to 01 . my boot loader of course was locked down when I tried to flash another recovery.. so I read and people suggested pit files along with tar so I did that. no firmware Samsung official or otherwise will try to install at all with the aboot.mbn intact within the tar . ive flashed and flashed ..everything... so then I got a 32 gb pit file and did a nand erase in odin...and I noticed that by doing that I have my stock recovery back . I then re flashed the proper 16gb pit file and it remained working..so now I have download mode and stock recovery both working but have NO SYSTEM at all installed and cant seem to install one....I need good solid advise..is it a paper weight or is ther a way to zip or tar back either by odin or stock recovery.. help please.
Click to expand...
Click to collapse
Are you sure you're on the mdl bootloader? What do you mean when you say you're on 4.3? That's not consistent with mdl bootloader. My guess is you're not on the mdl bootloader and that flashing the mdl tar in Odin won't work for you. In a terminal emulator on your phone type
su
getprop ro.bootloader
They'll tell you what bootloader you're on.
If you're not on the mdl bootloader flash the nb1 tar in Odin.
Sent from my Nexus 5 using XDA Free mobile app
correct information
I was on 4.3 before I updated I have flashed several tar files ..I don't have any system working on phone I can't do what you have recommended. But
The Information I gave came from the top of the the screen in recovery mode.
What version are you trying to flash through Odin?
Hey guys,
I had this Galaxy S5 SM-G900W8 already rooted, and after installing TWRP, after reset it told me the phone wasn't rooted and asked me to install SuperSU, stupidly I said ok.
Now, every time I try to install the stock rom, I keep getting aboot.mbn Error.
I tried installing both the Wind and Rogers versions of the STOCK ROM's via Odin to no avail. Where can I find the proper pit files for this phone?
Lollipop 5.1.1 was already installed.
Thanks in advance for any help.
I found the pit file in this thread:
http://forum.xda-developers.com/showthread.php?p=52329647#post52329647
I'm getting error for the pit file, ( secure check fail: pit )
Update: I managed to restore the phone using Kies 3. WHEW
After try to root with cf autoroot lollipop stock original, meesage with odin
<ID:0/005> There is no PIT partition.
I fixed this.
This pit file is original from Smart Switch downloaded Austria rom i9506 16GB
I grab this pit from temp folder after smart switch downloaded latest firmware for i9506
http://www.mediafire.com/file/yadsy36ul60tv3g/KS01LTE_EUR_16G_0719_hidden200M.pit
Thx