When returning to stock from custom rom(cloudy g3) I accidentally bricked my g2(d802).
Every time I only get the start of the bootanimation(the lg logo) and then the screen turns black(with backlight, with sometimes there flashes a bit of the other part of the bootanimation, almost thougt it was haunted or so) and the status led flashing as usual.
I tried to restore via download mode with the lg mobile support tool and with the lg flash tool, but strangely the progress on my phone and pc didn't match (it ends with my pc still on 80% and the phone already rebooting into the same state).
Even strange is, my pc recognises the phone most of the time and thinks it has the latest software. I also can't power of the phone or perform a hard reset/reboot to recovery.
What can I do to recover my phone if still posible(I only have it for maybe a week or 2 )
Related
HI, i need help, I have Lg G2 D802. It Hangs on LG logo screen with a blinking led. i can go to download mode but the pc just does not recognize the phone (drivers are installed)... if i connected and turn on the phone by normal way it gets stuck at lg logo but the pc recognize it, but if i connected in download mode does not recognized ! ( i need the pc recognized the g2 in download mode for using lg flash tool in order to flash .tot stock firmware) any fix??
what brought me to this is that i was on kitkat and i upgraded to lollipop everything went fine but when booted up the touch screen was crazy all over the place so i tried to go back to stock used the kdz method thats when i got the stuck logo i tried to factory reset but after clicking yes the phone reboots immediately
please help i never faced these problems with other companies i think this is my first soft brick?
Hey everyone,
This morning i was doing a backup on my lg d803 straight from twrp and the screen turned off. I left it like that for about 10 minutes to make sure the backup would finish.
However, the screen still wont turn on. The phone rebooted once into the lg logo and turned off. It is now stuck like this. It won't boot back into anything
-The phone won't turn on.
-It can't boot into recovery or download modes.
-It it not recognized by my pc in any way (win 10 64 bit with LG drivers installed).
-Holding the power button does not turn it on, not even to the lg logo.
-the button combo for recovery mode does nothing either.
alexander_the_great said:
Hey everyone,
This morning i was doing a backup on my lg d803 straight from twrp and the screen turned off. I left it like that for about 10 minutes to make sure the backup would finish.
However, the screen still wont turn on. The phone rebooted once into the lg logo and turned off. It is now stuck like this. It won't boot back into anything
-The phone won't turn on.
-It can't boot into recovery or download modes.
-It it not recognized by my pc in any way (win 10 64 bit with LG drivers installed).
-Holding the power button does not turn it on, not even to the lg logo.
-the button combo for recovery mode does nothing either.
Click to expand...
Click to collapse
I bricked mine last week. Got it into dowload mode (don't remember, google it) used lg mobile support tool and did recover phone from options and worked like a charm. Didn't even lose any of my installed apps.
Maybe battery level is low
Download mode did not work for me with low battery
I charged for about 2 hours and still could not get into download mode. i tried holding the volume up button while pluging it into the pc and nothing happened on the pc or the phone. No connect sound or anything.
Charging and using combo's don't always work, you should ideally boot into download mode before attaching. Perhaps you should try and make a MacGyver cable with a spare/broken usb charger to charge the battery directly - in-case the port or something is broken.
I flashed Resurrection Remix a month ago in my 1GB ram variant, and everything was fine until, one day, when I was operating camera in my phone, the phone blacked out, and restarted, and when the screen showed pattern to unlock, and any attempt to unlock the phone would lead to immediate restart, and then after 4-5 attempts, the phone started to restart in frequent short intervals only showing android logo on the screen.
I decided to flash ROM again but this time stock ROM, but this phone has a great history of not entering into recovery mode no matter what I do. It enters only on its will. So, somehow I again flashed TWRP, and then tried flashing stock rom with QPST tool, but, when flashing finished, the phone as usually restarted, but only again to be stuck in boot loop. I again tried to flash it. But this time, after the full installation, the phone became dead. No matter what I do, the phone doesnt even turn on. No vibration, no lighting of screen, and even its not detecting on connecting to the PC.
What could be the problem? Anything related to hardware? Please help.
I suggest you to bring the phone to the service center
vaddadi9953 said:
I flashed Resurrection Remix a month ago in my 1GB ram variant, and everything was fine until, one day, when I was operating camera in my phone, the phone blacked out, and restarted, and when the screen showed pattern to unlock, and any attempt to unlock the phone would lead to immediate restart, and then after 4-5 attempts, the phone started to restart in frequent short intervals only showing android logo on the screen.
I decided to flash ROM again but this time stock ROM, but this phone has a great history of not entering into recovery mode no matter what I do. It enters only on its will. So, somehow I again flashed TWRP, and then tried flashing stock rom with QPST tool, but, when flashing finished, the phone as usually restarted, but only again to be stuck in boot loop. I again tried to flash it. But this time, after the full installation, the phone became dead. No matter what I do, the phone doesnt even turn on. No vibration, no lighting of screen, and even its not detecting on connecting to the PC.
What could be the problem? Anything related to hardware? Please help.
Click to expand...
Click to collapse
I think its hard bricked
https://forum.xda-developers.com/lenovo-a6000/how-to/guide-hard-brick-lenovo-a6000-t3581892
Use this
So today i bought my LG G6.
There was a software update (i thing Oreo update) i installed it and when i got to the secure screen on the boot.
I type my PIN ,which was valid and my phone now is stuck on the secure loading screen.
At first i thought it was just going to take some time but after 25 minutes of waiting this started to worry me.
The phone is still on loop and when i use the Power Button and the Vol down the phone restarts but the same thing happens.
I tried everything from restarting it , to hard resetting (which doesn't want to work, the bootloader menu doesn't even show up with all the steps completed correctly) to throwing it on the ground.
(PHONE IS NOT ROOTED)
EDIT:I MANAGED TO SOLVE THE ISSUE BUT NOW IM STUCK AT THE PROVIDERS SCREEN WHICH IS (TIM) AND I CANNOT DO ANYTHING OTHER THAN SOFT RESTART
Regards,
Try put the phone into download mode and use LG bridge to reflash stock [Use the "Update error recovery" to reflash]
Hi Guys,
I got my G2 back from my brother who have not using it for a while.
1st day it was working. I plan to install Lineage or custom ROM today...thats when the issue start:
1: it wont go to recovery mode. Even thou I have rooted and install latest TWRP it will only boot to Hardware control key screen, only this screen and wont boot to the OS it will be stuck on LG logo forever....
2: tried to go to Download mode....the same It will go to the same hardware control key only....
3: when I plug in to my PC it wont turn off, keep on restarting after I press the power button for a while.... only if no cable connected I can totally turn it off...
For a noob like me....looks like my G2 D802 is brick :crying: ...any suggestion?
PS: windows detect it( As below picture ), off at all when I plug in AC.....It Will just show the LG logo and the LED just flashing non stop until I pull out the cable and turn it off...
This is what shown on the laptop No Disk1/2/3/4/5 of sort showing on the Device Manager and on the phone each time I try to go recovery or download mode belowh happen:
https://flic.kr/p/QH2HzE
https://flic.kr/p/2bs67ne
Update 1: I found out why the phone was brick. Seems like my Brother ask his friend to install Lineage 15.1 on the it. After everything is verified ok. He wipe and try to flash the rom in TWRP but.....it failed and suddenly just freeze and turn off the screen. Maybe bad ROM download or some step miss....so now the Phone has NO OS and would not boot to anything only the Hardware Key Management....that's all....help? Need the phone as 2nd phone for company lines....dont wanna take the iPhone 6 from my boss....
help?