I recently rooted my device (U8800 Pro, Official ICS) & unlocked FPS. I was installing apps from Huawei's new Emotion UI (like launcher, Music, Gallery etc.). Everything works great except the Gallery app. It kept force closing & camera also stops working. I installed it as system app so i can't revert back to original gallery.apk. So, i decided to install Official ICS again. I didn't have CWM installed. Step 1 of installing goes normal. But in Step 2, the phone restarts & now Huawei Logo shows up for a few seconds & phone restarts. It is stuck on logo.
Please help me now what should i do?????
Please!!!!!!!!
Try this!
mohit12345 said:
I recently rooted my device (U8800 Pro, Official ICS) & unlocked FPS. I was installing apps from Huawei's new Emotion UI (like launcher, Music, Gallery etc.). Everything works great except the Gallery app. It kept force closing & camera also stops working. I installed it as system app so i can't revert back to original gallery.apk. So, i decided to install Official ICS again. I didn't have CWM installed. Step 1 of installing goes normal. But in Step 2, the phone restarts & now Huawei Logo shows up for a few seconds & phone restarts. It is stuck on logo.
Please help me now what should i do?????
Please!!!!!!!!
Click to expand...
Click to collapse
you can take out the battery and press vol+ vol- and pwr key immediately after connecting to usb cable.....
this will start the installation of the rom without any gliches (as per me).
I had the same issue, but after trying with just the usb cable I succeeded to complete installation of rom.
if this helps tell me.
Related
Hi, first time modding and I've come up with a problem.
Baisically what's wrong now:
Phone is stuck at large green android logo when I turn on the phone.
Can't boot into Cyanogen
Can't get Clockworkmod to open
Phone only turns off with a battery pull
How I got the phone to this point:
Followed the instructions at wiki.cyanogen
(Backed up with titanium backup pro)
The first time I installed the mod I got stuck in a boot loop. But I fixed this by deleting data and cache in Clockworkmod and going through the steps again.
The phone and it's new mod seemed to work. I installed the google apps.zip, via CLockwork, still fine.
Then I tried to reinstall apps from Titainium Backup.
Some of these went well, but I started to get 'com.google.process.gapps' stopped working force close notifications.
I rebooted to see if that would make them stop.
But I got stuck in a boot loop of the Cyanogen animated logo, where it would boot, show me the unlock screen, I would unlock it, get another 'com.google.process.gapps' message and the phone would then freeze and reboot. The sequence then continued.
I tried battery pulling and tried to boot into Clockwork by holding down Menu Up and Power. But not after a while it just shows the green android logo. HELP.
I didn't read all!
So...
this problem is easy fix!
I spent 3 Hours with my blade to get my Blade II to work!
you have same problem which some other has posted somewhere here...
search on google or on Modaco: ZTE Blade TPT GEN1 or GEN2...
follow instructions!
now Blade II needs to work!
http://android.modaco.com/topic/343587-guide-de-bricking-a-zte-blade/
So i recently tried to upgrade my phones kernel and applied the aurora ics 4.1 update1a. The installing seemed fine, no errors so I pressed reboot now on my cwm (from the phones reboot recovery mode), but then it happened, the huawei logo appears and it doesn't go further than that. Tried many methods like removing the battery and running with usb, without battery and on usb, on battery and usb but non worked. If i leave it up a while, I press the power button again and then it turns off. So basically it won't boot further than the huawei start-up logo. Help ?
The phone random installed 2.3.5 on its own, so there the problem is solved.
i recently installed custom recovery with auto rec on my lg g2 (AT&T) and everything loaded fine. however, when i restarted the phone and locked the screen, upon opening it the screen is all messed up, its a bunch of lines but i can see the screen move when i wipe. it works fine everytime i restart it as long as i do not let it sleep. i have the 20k update and i am using nova launcher... any fixes?
http://forum.xda-developers.com/showpost.php?p=52414185&postcount=122
Hi Guys,
I am facing a peculiar kind of problem in my phone (G900F) since yesterday.
What happens is that, if I tried
i) To restart my phone from the phone (reboot menu), the phone stuc in boot screen and then vibrate twice then after 5-10 sec the phone start rebooting all along once again with 2 vibration and this process keeps repeating until I pull out the battery.
ii) To access recovery (both hard- key combination or from reboot to recovery option in phone), the phone reboots and it stays in the initial screen for about 45 seconds and then the screen went black and freezes there until I pull out the battery.
iii) To access download mode ( both hard- key combination and reboot to download mode option in phone), there seem no problem.
The weirdest part is that, if I remove the battery for 5-10 min and re-insert the battery and do any of the above options; the phone reboots and i get the home screen loaded successfully with no problem . I can also get into my recovery after this 5 mins switch off just like the above. I also found the phone lags a bit in this home screen.
I almost did all the combination to get off this problem (stated below) but I keep getting this problem again and again.
I was in Sixperience v 3.1 with Pheonix Kernel v 10 and Philz CWM recovery and tried the below to try to fix the issue
1. Re-flashed Kernel from Recovery (Also, tried to re-flash kernel after uninstalling Xposed but no use)
2. Re-flashed Modem and Bootloader from ODIN once again (G900FXXU1CPF7_BL_G900FXXU1CPB8_MODEM_LTE.tar)
3. Reflashed ROM once again as a fresh install through Philz recovery.
4. Restore the cwm backup from recovery (which was backed up a week before.)
5. Flashed Samsung Stock MM ROM (G900FXXU1CPFH_G900FPHN1CPFD_PHN.tar.md5) as a fresh install.
After this stock ROM installation is done, the phone struck at SAMSUNG flashing logo and the blue LED keeps glowing for more than 30 mins)
Nothing works. ? Any idea on what is to be done to fix this issue? I am not sure, what i did but this problem keeps coming even after trying of all of the options since yesterday.
Please help to with your expertise.
I am having a strange issue in my a6020a46(k5 plus). The first time i installed pixel rom from xda) the system booted up fine then after using for few hours i installed bean Gapps(mini version) but play store was unstable. It was never able to sign me up so i again fully removed everything for clean installation (dalvik/cache,data,system,cache). After installing OS i installed wifi+kernel fix and again bean Gapps which strangely didnt got installed unlike first time. Then problem began. When i rebooted it got struck into bootloop. I waited for 1 hrs but nothing happened. Then phone was not even going into recovery no matter what key combination i tried. It only got struck in penguine icon which kept restarting again and again. After many many attemps I was able to get it into recovery mode by pressing vol+,- and power button after immediately pluging it into charger. I again tried to install pixel but same problem occured. Then I tried installing other ROMs and it boots up but same pengiune icon is present there. I am not able to get rid of that icon nor able to boot up my phone with pixel OS. One more strange thing is happening and that is when phone is completely off and plugged into PC there is sound that notifies that ext device is connected and penguine icon comes in screen but when i power on my mobile then disconnecting sound comes and it never connects again untill i completely turn off my mobile and plug in USB. So summerising it here-
1) Pixel OS (no gapps+wifi,kernel fix) installed on 1st attempt
2)open gapps are not compatible so installed bean gapps mini version but play store was unstable+not able to sign in
3)did clean install but beanGapps didnt installed,errors were present. Installed wifi+kernel fix(by mistake did it twice). Booted and it got into bootloop
4)when device is off and connect via usb penguin icon pops up and sound of device connected play. when i switch on device usb disconnected sound plays and never connects again untill mobile is completely switched off again
5)installing other roms didnt removed penguin icon. other roms get installed but when tried to go in recovery mode it get struck into pengin icon(doesnt proceed until turned off and hold power and vol+,- button and immediately connected to power supply)
6neither pixel OS nor beangapps are able to get installed again. Bootloop (gapps ending with error 1)
I hope i can find answers soon. Thanks