Database Users

BAKED SNACK 1.3 ONLY 8.5 mflops?

I was getting 10.5 but getting force closes so I wiped and reinstalled anyone know what caused this

You probably didn't reinstall SetCPU and overclock the CPU to 1.3. It defaults at 1.0.

Thx running 10.5 again
Sent from my SPH-D700 using XDA App

Sent from my SPH-D700 using XDA App

Cam3ron1 said:
Thx running 10.5 again
Sent from my SPH-D700 using XDA App
Click to expand...
Click to collapse
Yup no problem.
Make sure you set it to minimum 200, maximum 1300 and scaling to conservative. Performance scaling should really only be used when you actually need the performance (Cause it takes more battery life), which isn't often with this phone.

Overclock widget settings???

Ok I'm still kinda a noob so hear me out and try not to judge me. Thanks! Anyhow I have an HTC Hero CDMA through Cellular South. I am rooted and running CM 6.1. I have downloaded Overclock Widget from the market hoping to get a little more speed and battery life out of my phone. I have read to start the overclocking at 250 min and 768 max and if that don't work to keep changing it til you find that happy place. Well my problem is that any setting I put it on it acts fine for a few hours then it starts making my phone freeze. I know ever phone is different but I was woundering if everyone could share their settings with me and I will give them all a try. Maybe one of you have the setting I need. Thanks in advance!!!
Sent from my HERO200 using XDA App

Raise your min to the next step, 345, I believe. Leave max at 768. If you still get reboots, lower your max to 728. Keep dropping your max until you quit getting reboots. Personally, my phone can run at 768 just fine, and even higher, but like you said, not all can.
-----
Sent from my CDMA Hero. I got some hot Froyo-on-Hero action here!

user7618 said:
Raise your min to the next step, 345, I believe. Leave max at 768. If you still get reboots, lower your max to 728. Keep dropping your max until you quit getting reboots. Personally, my phone can run at 768 just fine, and even higher, but like you said, not all can.
-----
Sent from my CDMA Hero. I got some hot Froyo-on-Hero action here!
Click to expand...
Click to collapse
I would lower the Max before raising the Min in this case.

stayclean said:
I would lower the Max before raising the Min in this case.
Click to expand...
Click to collapse
Sounds good to me. I'm just not a fan of 250 min. I feel it starves the device of needed processor speed when an app calls when the screen is off.
-----
Sent from my CDMA Hero. I got some hot Froyo-on-Hero action here!

Ok I am running 160 min and 768 max right now and it seems to be doing ok! I never thought about lowering the min! Lol!
Sent from my HERO200 using XDA App

babygirl17_06 said:
Ok I am running 160 min and 768 max right now and it seems to be doing ok! I never thought about lowering the min! Lol!
Sent from my HERO200 using XDA App
Click to expand...
Click to collapse
You might be too low at 160.
-----
Sent from my CDMA Hero. I got some hot Froyo-on-Hero action here!

What do you suggest?
Sent from my HERO200 using XDA App

superhero
running aosp gb overclocked at 710Mhz and low setting at 352 Mhz . new rom is a little laggy every now and than, but overall working pretty good. live wallpapers not loading,but not good for the hero anyways.

babygirl17_06 said:
What do you suggest?
Sent from my HERO200 using XDA App
Click to expand...
Click to collapse
Well, if you're running fine, I suppose 160 will work.
-----
Sent from my CDMA Hero. I got some hot Froyo-on-Hero action here!

Also what governor are u using. I suggest smartass or interactive.
Sent from my HTC Hero CDMA using XDA App

1200 mhz on galaxy s. Safe?

Im wondering if anybody can attest to the stability and reliability as well as safety concerns with running a galaxy s phonew at 1200 mhz. I see a lot oflash kernels boasting this overclock. Thanks in advance
Sent from my SAMSUNG-SGH-I897 using XDA Premium App

Flash and find out. If it doesn't freeze, your good. Some phones can't handle the oc. There's really no grey area, it will either be stable, or it won't. 1.2 is the standard, and is probably the safest. I'm at 1.48 and stable.
Sent from my SGH-T959 using XDA Premium App

I'm mainly concerned for overheating as I've cooked a couple pc processors
Sent from my SAMSUNG-SGH-I897 using XDA Premium App

Use setCPU and set up a temperature profile. I have mine set so when the phone hits 120 F, the processor scales down to stock clock speed and cools off.

Dan_Brutal said:
Flash and find out. If it doesn't freeze, your good. Some phones can't handle the oc. There's really no grey area, it will either be stable, or it won't. 1.2 is the standard, and is probably the safest. I'm at 1.48 and stable.
Sent from my SGH-T959 using XDA Premium App
Click to expand...
Click to collapse
What kernel your using?
Sent from my GT-I9000 using XDA App

Bullet[EDT]

U will not have any heat issues unless ur charging ur phone. When u charge a galaxy s phone ur gets very warm including in stock speeds

Definitely. The Infuse 4G has the same hummingbird chip overclocked to 1.2 ghz by default, so it should run with no issues. I can doing 1.3 ghz with no problem. Can't hit 1.4 though.
Sucks since my last phone could handle 1.6 ghz (through a custom 1.6 ghz DOW kernel, thanks Morific!).

It is safe but you lose battery life so that didn't work for me but it is safe and no overheating issues

Dunno what Kernel i used but it was by Morific, and was discontinued for being unstable, but my phone has been able to go up to 1.4, they tried a 1.6 but was far too unstable or something.

xriderx66 said:
Dunno what Kernel i used but it was by Morific, and was discontinued for being unstable, but my phone has been able to go up to 1.4, they tried a 1.6 but was far too unstable or something.
Click to expand...
Click to collapse
I think the Manhattan project messes with the environmental properties of the phone or something.
Sent from my SGH-T959 using XDA Premium App

Dan_Brutal said:
I think the Manhattan project messes with the environmental properties of the phone or something.
Sent from my SGH-T959 using XDA Premium App
Click to expand...
Click to collapse
Yes, the Manhattan project was a dud since it never really overclocked the device. In fact it only slowed it down.
But I requested a 1.6 ghz version of the DOW kernel from Morific, just for fun. Surprisingly it worked well with my old device.

advanttage said:
Im wondering if anybody can attest to the stability and reliability as well as safety concerns with running a galaxy s phonew at 1200 mhz. I see a lot oflash kernels boasting this overclock. Thanks in advance
Sent from my SAMSUNG-SGH-I897 using XDA Premium App
Click to expand...
Click to collapse
That depends on the phone a lot. I know lots of people who use 1200 but I did with Overstock and Tigers Blood and my phone would freeze. Also use set cpu for the same side to keep an eye on temp.
Sent from my GT-I9000 using XDA Premium App

I've had no problems oc'in, but it really does depend on your chip. Been running mine at 1420 for a week, super stable never gone above 29c under load. IMO, just have to give it a shot and see how stable it is for you.

I'm using Bullet and have been getting great battery life even with it fully OC'd. About 20-25 hrs with moderate use.

CrazyCharlie said:
I'm using Bullet and have been getting great battery life even with it fully OC'd. About 20-25 hrs with moderate use.
Click to expand...
Click to collapse
+1... im using Bullet with it tapped out and get pretty good battery life.

Can I get a link to Bullet? I've never seen it.

Can't not allowed to post the link to bullet....EDT's Site.

CrazyCharlie said:
I'm using Bullet and have been getting great battery life even with it fully OC'd. About 20-25 hrs with moderate use.
Click to expand...
Click to collapse
With what rom??

Overclocked mine to 1.48 and been running stable for a few weeks now...
Sent from my GT-I9000 using XDA Premium App

I'm stuck in CWM Recovery

Installed the Glitch kernel...
Everything was ok.
Turned up Mhz in Voltage control, phone restarted, won't work now.
Stuck in CMW recovery
HELP

FordDenny said:
Installed the Glitch kernel...
Everything was ok.
Turned up Mhz in Voltage control, phone restarted, won't work now.
Stuck in CMW recovery
HELP
Click to expand...
Click to collapse
You need that kernel cleaning script. I don't know if I'm allow to post the file here, and I'm bot sure what post it is again. I can tell you the file name is
ultimate_kernel_cleaning_script_v2_by_lippol94.zip
Hope it helps.
-Maniac

Thanks man. I'm back to norm
Sent from my SCH-I500 using XDA Premium App

FYI, the next version of glitch is possibly going to have a modified recovery that will have options to clear voltage settings and things to save us from problems like this

Do you know when it's coming out?
Sent from my SCH-I500 using XDA Premium App

FordDenny said:
Do you know when it's coming out?
Sent from my SCH-I500 using XDA Premium App
Click to expand...
Click to collapse
No, glitch has been recoding it from scratch so it will be a while, no eta.
Sent from my MIUI SCH-i500

I will patiently await its arrival.
Sent from my SCH-I500 using xda premium

V12 is out and does have the new recovery...
Some have been having issues with lag using the default deadline scheduler. CFQ has been great for me, I just change it on a reboot for the time being, have not gotten around to using the script that will allow the change to stock but it's out there...

Question:
Does Glitch kill the battery? I lowered VC to the minimum. When I first rooted and used the other kernel, I got excellent battery life. Now, TERRIBLE.
I did flash Glitch V12.
Sent from my SCH-I500 using xda premium

give it acouple charge cycles to recalibrate. Oh and I would wipe battery stats in cwm aswell.

droidstyle said:
give it acouple charge cycles to recalibrate. Oh and I would wipe battery stats in cwm aswell.
Click to expand...
Click to collapse
How do I wipe it?
Sent from my SCH-I500 using xda premium

Overclocking official 2.1

Is there any chance of overclocking official 2.1 rom
Sent from my GT540 using XDA App

mohnim said:
Is there any chance of overclocking official 2.1 rom
Sent from my GT540 using XDA App
Click to expand...
Click to collapse
Yeah, install Quarx Kernel, MMXTREM kernel etc.

How do I install the kernel
Sent from my GT540 using XDA App

mohnim said:
How do I install the kernel
Sent from my GT540 using XDA App
Click to expand...
Click to collapse
Flash the zip in recovery (for MMXTREM)

does anyone if it is safe to underclock??
About (122MHz ~ 245MHz)

Probably
It's stable on 122mhz on mine. But it's super slow and laggy. But battery saving

y
jhonnyx1000 said:
It's stable on 122mhz on mine. But it's super slow and laggy. But battery saving
Click to expand...
Click to collapse
So is it safe???
Or should I just put it to powersave mode??
I heard that it may decrease ur phones battery life. And from others that u need to put it at least to 245MHz so that the system can run!
Sent from my GT540 using Tapatalk

safe on mine
122mhz works on mine and is very consistent. It never crashed on that frequency. Don't know if it'll work on other phones.

Anyways thanks gonna underclock!!!
Sent from my GT540 using Tapatalk

I would also say two hundred better safe than sorry
Also battery on mine at eight hundred mega hertz is still eight or nine hours so really its only if you had no charger for longer than that that you would under clock
Sent from my GT540 RSpec using XDA App

Danzano said:
I would also say two hundred better safe than sorry
Also battery on mine at eight hundred mega hertz is still eight or nine hours so really its only if you had no charger for longer than that that you would under clock
Sent from my GT540 RSpec using XDA App
Click to expand...
Click to collapse
my phones usually lasts about 2 and a half days!!

I've noticed that the battery level is very unstable. For example the LG Optimus 2x's battery level changes every 1% but on the LG-GT540 it changes every 3-10%

jhonnyx1000 said:
I've noticed that the battery level is very unstable. For example the LG Optimus 2x's battery level changes every 1% but on the LG-GT540 it changes every 3-10%
Click to expand...
Click to collapse
Yes I have noticed that too!!
We should try and fix it!!
That would be great!!
Goππa ®o©k & ®o//

This is a kernel issue. Charging table is not properly written.
Sent from my GT540 using Tapatalk

pebe94 said:
This is a kernel issue. Charging table is not properly written.
Sent from my GT540 using Tapatalk
Click to expand...
Click to collapse
so is it like impossible to fix??

androidboss7 said:
so is it like impossible to fix??
Click to expand...
Click to collapse
Possibly not (as in it won't be impossible to fix)