using data connection during a call - HD2 General

im sure this usd to work, but recently ive noticed it doesnt. when im in a call, my data connection disconnects. normally this isnt a problem, but sometimes i will want to look something up on the internet while in a call. like i said, im sure this used to work, but now it doesnt. im on t-mobile UK with an unlimited data plan, i have a near full HSDPA signal. im running the CleanEX DsE v15 ROM with Radio 2.11.
any thoughts

should work on 3g, not on edge or gprs
don't be confused by the left hand network symbol showing an H, that's just what your network is offering. the signal bars icon must also be showing H

i have a H as the left hand icon, and a little h above the signal bars. when i start a call, the smaller h changes to a picture of a phone. if i try and use any web features it just times out. when i hang up the call, my data connection seems to have been disconnected, as it shows a T shape above the signal bars, then changes back to the H after a few seconds

Related

3g Voice Call Signal Strength

Hi All,
Im on Orange with my M5000, however I have noticed that when my 'G' (GPRS) symbol is showing I have good signal strength (exactly as I used to with my M2000) however whenever the phone switches to '3G' symbol my signal strength drops by 1 to 2 bars, which thens means in a lot of cases its not enough to hold a voice signal.
What can be done about this as Orange seems to have great 3G coverage (i nearly always have a 3G data connection which works fine, I just wish I could use it as a phone too.
Cheers
Shaun
Shaunfarris said:
Hi All,
Im on Orange with my M5000, however I have noticed that when my 'G' (GPRS) symbol is showing I have good signal strength (exactly as I used to with my M2000) however whenever the phone switches to '3G' symbol my signal strength drops by 1 to 2 bars, which thens means in a lot of cases its not enough to hold a voice signal.
What can be done about this as Orange seems to have great 3G coverage (i nearly always have a 3G data connection which works fine, I just wish I could use it as a phone too.
Cheers
Shaun
Click to expand...
Click to collapse
Thats odd mines the reverse!!
On my M2000 and M5000 the G signal is about 2 bars, when the 5000 has U coverage my bars are full.
Matt

3G and other Symbols

Hi i have the HD2 on 02 and when im in a 3G area my network operater changes to show 3G 02-UK but my signal bars dont change they stay the same as
(the 8th one down on the left of page 39)
the symbol to the left of the signal bars shows H with two arrows i havent seen my signal bars change to show
(5th one down on the right of page 39)
why is this?
Am i connected to 3G?
I have never seen my signal bars change like the ones on page 39/40?
http://www.o2.co.uk/deviceinfo/device-pdfs/htchd2eng.pdf
The manual is wrong.
My O2 HD2 on t-mobile shows 3G/G/H in a white box when no data connection on.
When data connection is on, you will see 3G/H/G (and possibly E [t-mobile dont have E]) with arrows, indicating data is on.
The manual suggests that the signal icon will intregrate with the data icon whereas we see it as data icon then signal icon.
What you are seeing is correct.
When it shows 3G with arrows, you are connected to 3G, H is slightly faster 3G, E is edge (slightly faster 2G) and G is GPRS 2G.
ok thats cool so when i see the H with arrows this is faster than 3G so what are the actual speeds of 3G & this H thingy? and does this mean that my HD2 is connected to a faster connection than my mates iGay 3GS
HSPDA: http://en.wikipedia.org/wiki/High-Speed_Downlink_Packet_Access
The actual speeds may vary, depending on network, tower distance, how many people connecting on that tower etc etc.
basically
GPRS=2G
EDGE=2.5G
3G=3G
H (HSDPA)=3.5G

[Q] Sporadic Signal Loss

Okay so i've got an aria rooted and flashed with the Liberated 2.2 rom. I've been using it for the past 3 months and I've noticed that I will go from full service while a phone call is comming in and complete signal loss when I answer it. I have set the phone on a table and watched the network signal strength go from -113 dBm and 0asu to -81 dBm and 16asu and vise versa. I have also noticed that when I lose signal my "H" for the data goes with it and service comes back a few seconds later very strong but showing "G". From there it will go to "E" then back to "H".
Could anyone explain this or have a better reason as to why this is happening? Maybe its just based on the connection where I live but I've used the app Antennas and the tower is about 1/3 mile away.
Any info or help would be awesome
Thanks
i'm not sure why this would happen outside of a poor bit of service where you're living.
i used the various roms for the aria and never had any sort of service loss issue.
as far as the icons switching around, e = edge network (2g), h = hspa (3g). when your phone drops its connection, it tries to reconnect as fast as possible, usually with edge, then after its strong it looks for the 3g connection.

[Q] Omnia 7 data connection problem

Hi, since I got this phone and I've been having problem with the data connection, wifi is working fine, but 3G is not, it shows the 3G symbol but keep switching to H symbol and back again to 3G constantly, i never been able to surf the web or do anything online on 3g connection since i got it.
I tried putting in the setting from my provider and got the samsung network app thingy but nothing helped, even after updating to NoDo.
This is really bothering me i cant enjoy the phone when im outdoors, i switched back to my iPhone 3gs temporarily.
I really hope this can be solved.
I'm thinking if there is some way to make the phone only works on 3G and turn the H off.
rhythmosis said:
Hi, since I got this phone and I've been having problem with the data connection, wifi is working fine, but 3G is not, it shows the 3G symbol but keep switching to H symbol and back again to 3G constantly, i never been able to surf the web or do anything online on 3g connection since i got it.
I tried putting in the setting from my provider and got the samsung network app thingy but nothing helped, even after updating to NoDo.
This is really bothering me i cant enjoy the phone when im outdoors, i switched back to my iPhone 3gs temporarily.
I really hope this can be solved.
I'm thinking if there is some way to make the phone only works on 3G and turn the H off.
Click to expand...
Click to collapse
H is for HSDPA and is far more faster than 3G. I reckon you run ADC on startup using samsung tools and hopefully the problems with connection will be resolved. Alternatively contact your sim provider for network configurations.
Here it also switches between H and 3G, or well it did on my other wp7 phone my (european) omnia uses 3g+. That's normal; the H mode probably eats your battery alive, and it only switches to it when your data connection is active (i.e. data is being transferred)
Your problem appears to be an Access Point problem, you can configure one yourself at the mobile connection settings page. (bottom). Check the web for the settings you'll need.
You see most phones are configured automatically by their providers, but the omnia probably isn't supported.
Hope this helps
the APN for China Unicon is "3gnet"
just add it your 3g connection will work.

Only using data/internet with 'H' or 'H+', not 3G

Something strange I've noticed with my Galaxy S II is that data / internet will only work if the 'H' (for HSDPA) is in the status bar, but not with '3G' there...the green arrow will appear next to the 3G when I try to connect to something but it will just time out unless it happens to switch to 'H'.
Anyone know why this would be? Is only the HSDPA network working with my phone, but regular 3G won't?
It is possible that the 3G cells in your area are fully loaded with users.
Sent from my GT-I9100 using XDA App
nvm
i didn't read it well
Same problem here, on 3.
Wondered if it was the phone or the network! If it's a problem with the phone it'll be fixable/covered by warranty though, right?
Same here, it sits on 3g then i try to load a page etc and it goes to h like it carnt use 3g , im on t mobile and they have full coverage where i am
Sent from my GT-I9100 using XDA App
I found an older thread that says it's a feature, keeping the phone in 3G mode to save battery until you do something that requires data which switches it over to H. I've kept a closer eye on my phone and that does seem to be what it's doing, usually taking a second or two to switch over each time I use data.
However, there have still been some times where it stays on 3G and is unable to load data.
Yeah i think your right and also it does not change sometimes and kinda hangs, be nice for it to switch over to H abit faster without battery drain.
AXIS of Reality said:
I found an older thread that says it's a feature, keeping the phone in 3G mode to save battery until you do something that requires data which switches it over to H. I've kept a closer eye on my phone and that does seem to be what it's doing, usually taking a second or two to switch over each time I use data.
However, there have still been some times where it stays on 3G and is unable to load data.
Click to expand...
Click to collapse
Sent from my GT-I9100 using XDA App
I have the same issue with my phone to on t-mobile, not working on 3g then working on H.
It is a right pain to be honest.
No way of stopping this battery save? I would rather use more battery.
It's the network. I have no explanation but only Edge and HSDPA work whether on Samsung or Nokia.
Just tested, this does not occur for me, at least right here, right now. Comfortably loading pages on Google with just 3G signal (T-Mobile UK).
It's faster when I stand on my bed upstairs for HSDPA but 3G does work. Stock firmware from T-Mob, no modifications.
AXIS of Reality said:
Something strange I've noticed with my Galaxy S II is that data / internet will only work if the 'H' (for HSDPA) is in the status bar, but not with '3G' there...the green arrow will appear next to the 3G when I try to connect to something but it will just time out unless it happens to switch to 'H'.
Anyone know why this would be? Is only the HSDPA network working with my phone, but regular 3G won't?
Click to expand...
Click to collapse
Hey mate,
I have the galaxy s i9000, with optus here in sydney. same problem, only switches to "H" when i make some sort of data request (load a page, open an app that uses internet), it takes a couple of seconds to switch from 3G to H. Sometimes, it keeps flicking back and forth between 3G and H like its having problems connecting to H
I complained to optus, they reckon i'm lying. Go figure.
joeykatoa said:
Hey mate,
I have the galaxy s i9000, with optus here in sydney. same problem, only switches to "H" when i make some sort of data request (load a page, open an app that uses internet), it takes a couple of seconds to switch from 3G to H. Sometimes, it keeps flicking back and forth between 3G and H like its having problems connecting to H
I complained to optus, they reckon i'm lying. Go figure.
Click to expand...
Click to collapse
Sorry.. just to add on, i've tried about 13 different modems on my i9000 and it happens with all of them.
The only fix I've come by? dial *#301279# and disable HSDPA altogether thats the only way my phone will actually load any data on 3G
I have the same thing, but as i understand H and H+ are the highest form of 3G, not a different thing. So I am wondering what mode we are in when 3G appears. UMTS?
Its all very annoying to be honest.
None of my other phones have this problem as they always stay on HSPDA
Same problem here to the extent that pages fail to load on 3g and come up with the error then when I refresh the page once its on H it loads straight away.
Actually this problem is making my phone more or less not usable.
I use the slingplayer alot, keeps skipping on the Galaxy S II as it seems to keep switching between H and 3G.
Put the sim card into my ZTE Blade (Orange San Francisco) and streams constantly with no problem with signal staying on H.
With all the threads relating to 3g and connectivity issues..we can deduce that SGS2's modem really sucks big time..and still no firmware update to correct this even though large number of people is facing some sort of problem with mobile internet which is a main function on todays smartphone.
Sent from my GT-I9100 using Tapatal
Anyone know who to e-mail with examples at Samsung?
I guess they won't fix a problem if they don't realise there is one.
Some people will prefer longer battery when its on 3G then H, others will want the constant H.
I got mine a week after it released. The first two updates mine did the same thing, but instead of timing out, it would drop all signal and display the circle. After a reboot signal would come back. From KE7, it has not done it again.
AT&T in the U.S.
same problem, mode switches around when using data, 3 australia

Categories

Resources