How to dial DTMF tones within a call? - Touch HD General

Hi
Calls to an IVR (Interactive Voice Response) systems require to dial DTMF tones. How is it possible to dial those tones, after a call is dialled and answered?
Thanks

Ok, things sorted out
Somehow, pressing KEYPAD did not bring the numbers keyboar on my new HD. A soft reset had just sorted that
Thanks

Related

sending DTMF tone

I want to send telephone number from addressbook in line as DTMF tone. How I can make it (soft and so on) ?
Just found the answer about 15 pages down. Use commas between the dialed number and the numbers you want to add. Each comma is a couple seconds pause. I tried it and it works!!!
8)

Beep sound when dialing phone numbers

Hello,
How I can disable beep sound when dialing phone numbers?
Goto Start > Settings and select Phone, then next to Keypad select Off.
aa that simple and I didin't find it
Don't you disable the tones for online services as well, by doing that?
I mean, sometimes we dial a number and, during the call, we are requested to dial pin codes, phone numbers, etc. By disabling the keypad signals don't we disable those too?
conao said:
Don't you disable the tones for online services as well, by doing that?
I mean, sometimes we dial a number and, during the call, we are requested to dial pin codes, phone numbers, etc. By disabling the keypad signals don't we disable those too?
Click to expand...
Click to collapse
I just tested it. Turning off the keypad tones doesn't affect tones dialed when you're connected.

How to control dial speed?

When the phone number is in the form "111-111-1111 p 2222" the phone dials 111-111-1111 number, then pauses and then sends 2222 as DTMF tones.
My question is how to accelerate sending those DTMF tones? For me it sends about two tones per second which is even slower than I can press the buttons manually. I'm sure there should be a registry setting to send tones faster.
Thank you!
Konstantin

Change Menu for incoming call

Hi,
can we change the menu for an incoming call at our pdas? (WM6)
Big thanks

Display Dialer/Dialpad on incoming calls

I have searched without success. Is there a setting that can cause the Dial Pad to show on incoming calls? I can press the Keypad soft key but it would be nice if it was automatically displayed.
Thanks in advance
Buehler ? , Buehler ?

Categories

Resources