I used ril.h and some ideas posted in this forum to measure GPRS band strength and I find that when GPRS is connected (even if there is not GSM signal) the returned value is always 183.
Although GPRS is like a digital signal (it only takes two values: 0 or all), when there is not GSM signal, GPRS signal should not be present, but the returned value is 183 anyway.
Any ideas?
Thanks.
I believe it might be a bug with the ril on XDA I. XDA II does not suffer this problem.
Ben
I am wondering if any other dll could do the work fine.
Any ideas.
Thanks.
IMHO GPRS signal shows if GPRS modem on or off. And this signal should be without GSM signal.
Is Android any better than windows as far as signal reception? coz mine is really bad only get a low G signal most of the time. I have standard settings as shown and with virgin ,live in west sussex
Since the actual gsm phone hardware (radio) is seperate from the hd2 hardware and it is controlled by the radio rom, Android won't probably have any difference. Only signal bar "reporting" or 3g - 2g switch threshold "may" change and that is software.
Note: radio does not mean fm radio.
I get better call quality and reception in windows...
I noticed after disabling the improve signal tweak in the diagnosis thread I am yielding significantly higher download and upload speeds. I think the issue was that now my focus is only using digital signals rather than digital and analog signals as suggested by dual mode...obviously if you are in a bad reception area the tweak would be beneficial....but I live in Chicago and don't need it....anyone notice speed differences with it the dual mode setting disabled rather than enabled in good reception areas....i have Samsung focus rev 1.3, mango beta 2 build 7712, and hsdpa/hsupa enabled
Samsung Focus At&t USA
Hello,
I have a huge problem with my Galaxy S5 SM-G900F. I bought it abroad and when I used it for the first time in my country I saw, that there is a problem with 4G/WCDMA connection. When I put my sim card to the phone and set all the preferences in mobile connection menu to "Auto" there is no possibility to call or to recieve calls (even if i saw signal strength meter showing some marks). I can only recieve and making call when I set "only 2G" option and manually select my network. But signal is also very poor.
What I have checked yet:
1. Other sim also doesn't work good.
2. After *#06# i saw my IMEI and it is the same under the battery and on the box (doesn't start from "00") so i think that it is not missed (efs folder).
3. Change firmware with KIES and ODIN for the other version - no changes. Also flash some other "modem" files with Odin with no success in better signal.
4. When im on the free air the signal strength is even at maximum level, but immidiately after going to my house - there is no signal. I saw also, that when im in the city i can connect with 2G network (only), but when im on a village there is no signal at all (even 2G...)
Do you have any ideas what can be wrong? Is this hardware failure? Maybe something with antenna? What should I do before going to gsm service center? Maybe i should change kernel and try some of the custom roms?
Thank you for your help.
regards
Mario
I have been using jio 4g for past 2yrs. The internet connection was good. But for the past 6 months I am facing frequent disconnection of the internet. So I go into flight mode activate and deactivate it again the net connection will be good for a minute and then it drops again to b/S. Frustrated I changed the SIM. But same problem. The bio customer care says it to update firmware! Which was not available and at last they told me to get the mobile serviced. So I swapped the SIM to another mobile and checked. There was no problem in that mobile. Please help me. Whether it is due to SIM or the band problem with mobile. I am using a stock firmware
Ps. Even I resetted, rooted
Set the network type or RAT or network mode to LTE (4G) only, then the phone should stay on the signal even when the signal is low for a second, around -120 rsrp (signal), specifically it should normally follow the parameters sent by the network: qRxLevMin (it is half the rsrp), qQualMin (sometimes, it is the signal quality), sNonIntraSearch, ThreshServingLow (both are ranges around qrxlevmin, one for entry threshservinghigh, one for exit). These parameters should nornally not be followed with LTE (4G) only. But only if the signal drops below the limit for a second. Else, it is a waste of resources, both for you (battery, etc), and the network, though the network can deprioritize cell edge (low signal) users.
To do so, there are extended network modes (for sim 1) in a menu that comes with Android, it is called 4636, Testing, Phone info, Device info, etc. There are apps that open 4636 without root, that offer: mode selections, lte only, anything cellular related that opens 4636.
Hold the phone on its top, not its bottom, for testing, the primary reception antenna should be at the bottom for A 2016, you can check this in *#0011#, it is "ant rsrp diff", it is positive when the primary reception antenna is better, negative when the diversity reception antenna is better, the diversity antenna should in most cases power on when the cellular is in use and start measurement, in contrast to the primary that's just switched on.
The signal can be measured in *#0011#, rssi is the signal strength of the frequency, the signal strength of intra freq (same frequency) neighbors (other cell towers etc) may differ slightly anyway because it's missing a decimal point; rsrp (good maybe at least -120, get it closer to -1) is approximately the signal strength of the cell, it is a few antennas in the long rectangular boxes on a cell tower, note that it is the measurement of the reference signal not the data that is being sent to your phone; rsrq(good maybe at least -15, best -1), sinr (good maybe at least 0, best 40), are signal quality. The "registered plmn" is the currently connected operator (mobile country code and mobile network code), if it changes (different compared to the sim), the signal is low! The "PCI" is the currently connected cell, note that there are only ~500 of these, so to identify the cell you can use both PCI and TAC (region), if the pci changes and the signal strength drops, well, the signal dropped and a reselection is made to an inferior cell, which can then drop data... in this case contact your mobile network operator but they might not make changes if it only affects a few users. You may try to lock band/etc to the good cell that sometimes drops in quality for a second but overall better than the neighbour cells.
Here's a short list of scenarios that can cause problems in connectivity, not all.
1: Low signal, plain old low signal. If the phone can't register VoLTE the bands that can be connected to may be restricted on some MNOs.
2. The antenna is closed and this causes low signal.
3. Low signal of the serving cell, the signal of an inferior neighbour cell matches (above parameters!), the phone changes to another antenna on a cell tower, quality drops and so does the connection. On another cell tower or there are 2 antennas on 1 cell tower, for example 1 facing the azimuth 180 degrees, another 270, the phone being in 215 degrees is unfortunate!
4. The antenna is open and receives interference (and reselections, sometimes good) from neighbour cells.
5. Good signal but it has been echoed a bit too much.
6. Reject causes and others, where the connection has been disconnected for some reason. Probably not in this case! It is viewable in *#9900# > Take cp log > copy to internal sdcard. It is in the /internal storage/log/LitmusLog. Scroll down to the reject cause section, those are error codes.
None of these codes/volte are working: The CSC is not applied correctly! Flash stock rom and open the stock recovery or copy /system/csc/...csc.../system/ to /system/etc/.
I do not recommend anything EFS/PIT, making a backup of efs is OK!
Hi,
I am facing the same problem with a7 2016 with JIO sim.
The mobile is purchased in dubai and when insert jio sim in india, was not able to use volte service.
So I flashed official indian rom. Everything is fine except net speed. Net speed between 1-5am is very fine but in day time speed reduces.
Everytime i have to restart data to use net but after a while same problem occurs.
Tried in both sim trays. I am using single sim in mobile.
Pls provide a solution.
Regards
//aftab