Hi Guys,
first of: Great Forum!
I hope you can help me with my problem.
I bought an Car-radio from Blaupunkt namend "Hamburg MP68".
It has an buildt in bluetooth handsfree-phone system and it works great.
I should mention that there is an extra microphone connected at the radio and placed right on top of the horn at the steering wheel. So the signal of my voice goes into that mic..through the radio and via bluetooth into the phone.
BUT: I was told my voice is a bit bad to hear because the volume is too low.
Hope you guys understand what i mean..I'm not a native english speaker;-)
Sorry for that.
Back to the Problem:
The Blaupunkt support told me, that i can't turn up the microphone volume in the radio. It must be turned louder in the telephone.
I dont know any way to do this...
The system volume should have no effect on the problem I guess.
So there is still "settings/system/microphone AGC". There I find an option that the build in mic of the P4350 adjusts the level of volume concerning to my voice.. But does this effect the bluetooth signal that "carry's" my voice??
I bet it doesent.. So have you any ideas how to solve this ( I admit ) very special problem?
Thx
Last but not least: I'm using the original HTC windows mobile 6 rom... Yes there are guys like me out there using original roms... ;-)
Related
hi all
i have a parrot bt handsfree installed in the car. i used it with my nokia 6310 and volume was really good. i could unterstand everything while going 160km/h on the highway.
now i have my xda2 which i use with the parrot as well. but volume is REALLY low. i know how to adjust the vol with the slider of course it's all up. but still too quiet. it's acceptable for driving in town but that's all.
is there ANY way to make that louder? i realized that with my old mdaI volume of the built in speaker went down when doing the upgrade to ppc2003. maybe this is an issue here as well?
maybe m$ lowers the volume so there will noone to sue them because of defness
pls help
regards ize|man
Hi guys,
I've been having alot of problems regarding my Hermes incall volume - it's whisper quiet. It doesn't seem to be the ROM (i've tried 3 now, the official WM5 and 2 WM6) nor the radio (i've tried 1.40 and 1.43)
I've also had a look on the forums to no avail, any fix seems to not apply to my system.
I know it's cheeky to start a new thread, but if I can't find a resolution I think I'll just sell it on the bay.
Cheers
p.s - I have ensured that it is to the fullest using both the scroller and the speaker during a call. The rest of the volume on the phone is fine, loudspeaker and ringing etc.
Ringing volume comes through your speaker in the back, and so does the speaker phone option. Your head piece might be going bad, that might be the reason why you dont hear it loud.
If the phone is still in warranty, then send it to be replaced!
Did a search, but "A2DP Volume" returns mainly headset reccomendations etc.
Just got a Altec lansing T515. Bargain at just £15 inc p+p!
Paired up fine with the HD2 and seems to work great so far (for the price).
My only dissapointment is that the volume controls on the phone do nothing to the volume of the headset/speakers.
I was really planning on getting some good use out of this wireless audio through a better amp and speakers but would really need to be able to use the HD2 as a remote control (Inc volume control).
Is there an app/utility/reg hack that will let me adjust the A2DP volume directly on the HD2???
Any and all advice greatly appreciated.
Cheers.
try it with windows media player and not the htc sense music player
Thanks mate, tried that.... same deal (almost).
When I adjust the volume inside WMP it still does nothing to the volume of the speaker/headset BUT when I press the mute button or lower the vol to 0% the sound on the BT Speaker DOES mute.
Also at one point I did get some funky 'pairing' problem where the wireless volume was changing using the HD2 volume rocker but the sound quality was terrible. Not sure what happened but I switched off/on bluetooth and when the devices paired again - the sound was back to good quality but the volume no longer worked.
Can anyone please confirm that I should be able to control the volume using the HD2 on ANY A2DP headset/speaker?
I'm currently using EnergyRom Maxsense 23xx 24th July.
Might switch to the 21July 23121 CHT ROM instead to see if that changes things.
But can anyone first please confirm that this SHOULD be working? or let me know of a regHack /cab/app I need to use or apply to get this 'remote volume' working?
Anyone help on this ^^^ please?
Same problem here with expensive Sony headset and reasonably priced JVC. Report it to HTC as a fault. No fix yet afaik
hmm well im getting my jaybird sportsband in a few days through mail, ill report in on if they work or not
This problem i have with all my bluetooth headsets ( i have had 3 ) and also have with the altec lansing soundblade (a bluetooth speaker - really cool)
the problem is that the volume control in software only effects the audio drive,a but A2D2 driver is on a different path so not affected.
For me has not been a problem because volume is always outputted at max via A2D2 and then i use volume control on the headsets or the speaker to reduce as required.
But i see if you have a headset without volume control then this can be a major problem.
Only method i did find to adjust volume via software was install SRSwow and in the options it is having 2 gain settings, input and output. Adjusting these does affect A2D2 volume.
I know its not a fix but it is a work around that may be usefull untill someone has a better option for you
Thanks very much for your input peeps!
rumpleforeskin: (Funniest name Ive seen all week lol)
Sounds like its not just a problem with my headset/speaker (or headset / ROM combo).
Ive got volume controls (which do work) On the headset adapter and on the speaker, but I REALLY want/need to be able to control volume remotely as I was planning to link the adapter to an amp without a remote control.
Looks like SRSWow might be the solution for now....I'll give it a try and report back tonight.
Thanks again for all your help chaps.
I actually fear this could be a demonstration the output audio is hardware wired and not software driven, thus meaning full incall recording will never be possible.
ephestione said:
I actually fear this could be a demonstration the output audio is hardware wired and not software driven, thus meaning full incall recording will never be possible.
Click to expand...
Click to collapse
doubt it man, on the iphone 3gs on 3.0 u couldnt switch the volume of the headset through the phone but now with the 4.0 software u can , so its just a case of misssing software.
I use tcpmp and I can control the volume from the software while using my BT headsets (peltor)
rumpleforeskin said:
....Only method i did find to adjust volume via software was install SRSwow and in the options it is having 2 gain settings, input and output. Adjusting these does affect A2D2 volume.
I know its not a fix but it is a work around that may be usefull untill someone has a better option for you
Click to expand...
Click to collapse
Tried this ^^^, Works great for everything, thanks!
Only slight problem is a ~4 second lag between adjusting the volume and the change in actual volume.
Dont suppose there is any tweak to remedy this??
Thanks again for the help.
cubalibre79 said:
I use tcpmp and I can control the volume from the software while using my BT headsets (peltor)
Click to expand...
Click to collapse
This ^^^ works perfect! No lag when changing volume or anything! Great for music and video.
Thank you very much!
Cheers guys.
When I'm using a wired headset to talk to someone on a call the volume is kinda low, I have it set max but its still pretty low, works fine on speaker or BT. Also the same wired headset works very loud when on a movie or music, just low when on a call.
Any fix to this?
Would like to know this aswell... Impossible to hear what people are saying when using the headset
I too find that headset and speaker volume are low. ( comparison to few other phones )
Cannot hear in a noisy environment.
Tried Volume + but does not seem to help .
I experienced this problem as well. Looks like this is a hardware problem (either the pin or the socket).
Try using a different headset - one without a mic. You sould see a significant gain in volume.
Sent from my GT-I9100 using XDA App
Its a hardware issue, swapped my phone for a new one today and dont have the problem anymore.
The service menu edit doesnt really help at all and the volume gain is minimal.
Anyone else having issues like this should request your carrier or samsung for a replacement. It only happens to a handful of phones.
I assume there are two seperate audio chips, the yamaha one for audio and another for voice calls??
Can anyone confirm?
I have a problem when I go with the earphones listen music o the radio if I receive a calling I cant speak to the phone because it doesnt work if the earphones are pluging on the device.
That it's very anoying and I have to unpluged the earphone, and when the calling is finishe the music is playing through the speaker phone.
I need a solution.
Thank you very much
Does the microphone work when you aren't listening to music?
Have you tried switching from speaker to headset softkey option within the phone call to get it to work?
I have Jabra Chill and everything works perfectly...what is your software version
The problem is when you pug your headphone in the phone the micro doesn't work and if you receive a call the person who is calling you doesn't hear anything.
dlamber7 I dont Know how is the soft key are you talking about because when I receive a call in the screen of the phone is speaker mute and anothes icons I dont remember, thank you anyway
rikee said:
I have Jabra Chill and everything works perfectly...what is your software version
Click to expand...
Click to collapse
My Software version is 7.10.7720.68 TOUCH-IT modify ROM
I got the same Problem. Do your volume buttons work?
My guess is: I used the headphones on my iPod and pressed a button on the headphones - since then they do not work with my phone any more..
My volume keys works perfect, thank you...
It will solve upgrade the SO 7740...until I know that it solves my problem I dont do anything.
Well I've been using my trophy for almost a year now and never had that problem, despite frequently listening to music on it (on headphones right now, and just did a voice search through the handset microphone), so I can't imagine what could he causing your problem.
The only potential workaround that comes to mind is to get a pair of headphones with a mike in them, and use the phone hands-free.
Goranius said:
I have a problem when I go with the earphones listen music o the radio if I receive a calling I cant speak to the phone because it doesnt work if the earphones are pluging on the device.
That it's very anoying and I have to unpluged the earphone, and when the calling is finishe the music is playing through the speaker phone.
I need a solution.
Thank you very much
Click to expand...
Click to collapse
Are you using the headphones that came with the phone? Are you talking about the microphone on the phone?
Joe
I dont use the hedaphones that came with the phone I use a sennheiser, these work perfectly with a nokia (N8-00) and I dont know what it is the problem.
I try to find the original headphones and I will say if the problem it solves.
And I am talking about the microphone on the phone it doesnt work it is like the phone doesnt recognize they are a headphones and no a handset.