My unlocked Cingular 8525 can't connect to (Globe)GPRS/3G here in the Philippines. I tried the configuration sent by Globe's CRS and still it didn't work. Your suggestions will be greatly appreciated. TIA
Related
I have a HTC wizard (Cingular 8125) which I flashed to Mr Clean ROM. Now I can not connect to GPRS. whenever I try to connect, it says there is no modem. In the settings I selected modem as cellular (GPRS). Am I missing something? Please help.
BigMonty
I'm using my old MDA which I unlocked for my cingular sim card but cant get the internet to work...
any suggestions?
Help needed to get back to WM5 (cingular 8125)
Please can some one help me.
I have tried to get my cingular 8125 back to the wm5 operating system.
I used the hard reset and the soft reset but keep ending up with a multi coloured screen.
I have looked but I cant find the solution.
The website weare I fine the program is this,
http://www.imei-check.co.uk/m3000unlock.php
Please Help Help Help Help Help Help Help Help Help
Sounds like your stuck in the "bootloader" screen
This is where you would flash the ROM I believe.
Just connect it to your computer and start your ROM.
If I am not mistaken it should reboot at the end of your ROM loading.
claroscuro said:
Help needed to get back to WM5 (cingular 8125)
Please can some one help me.
I have tried to get my cingular 8125 back to the wm5 operating system.
I used the hard reset and the soft reset but keep ending up with a multi coloured screen.
I have looked but I cant find the solution.
The website weare I fine the program is this,
http://www.imei-check.co.uk/m3000unlock.php
Please Help Help Help Help Help Help Help Help Help
Click to expand...
Click to collapse
When your 8125 is at the multi-colored screen, is there also a small message in white text prompting you to send? If so, you need to push the green hardware phone key. This sends info to the mfg, to get the 8125 operating again.
8125
2.25.11.102
Same as Claroscuro. Need to get WM5 back from installing iPhone skin. Tried soft and hard resets and iPhone skin still there. Can I re-install WM5, as I would with any PC OS?
Please help.
Thanks!
rapanui
Hi,
I have an XDA Orbit. Everything works ok except when I try to use the phone, It searches but cannot find a network. The inserted SIM is o2 Pay&Go. It does ask for my pin on startup and can read the SIM history but when I try to call, the calls ends after about 2 seconds and it comes up with the following error message:
"Cannot complete the call. The signal may be unavailable or the phone number may be invalid. Verify the number and try again later"
The SIM is ok as I have used it in another phone.
Any suggestions guys...
Regards
Brian
is the phone blocked by o2? if not try flashing an official o2 rom
Not sure if it is locked to o2, I have tried the o2 SIM and a T-Mobile SIM but both give the same result, unable to find network.
I have flashed it with the official o2 WM5 rom and the WM6 upgrade and I ahve tried a different radio firmware but same result...
I would welcome any further suggestions.....
Try engineering mode with GSM reset
Hi,
Thanks, I have experience of successfully flashing the orbit but "engineering mode with GSM reset". Some help please as to how I do that.
Hi all,
After unbricking my Omnia 7 and installing the original rom (T-mobile Germany) I cannot access the Vodafone NL network anymore. I checked the lock status but everything is unlocked (see attachment). I reinstalled the Samsung Network Profile tool and set the network to Vodafone NL. Still I can only make emergency calls. I have other sim cards without luck.
Anyone a solution for this problem?
Ron