hi,
can anyone direct me how to pairing my laptop by using bt with my mobile without asking a pin or pass code.........
and it's possible to do it by rebuild my bt software.........
and if its how i can do it.............
Thx........
Related
8525 Bluetooth tethering help!
I have done all the necessary steps to setup the bluetooth connection.
But when Dial, i get Error 692: There was a hardware failure in the modem?
Does anyone have any clue? The hardware should work because I can do it successful did it on my MAC OS X using bluetooth tethering..... but my work machines is Windows XP, SP2
Thanks.
I tethering it before using bluetooth on Windows XP, then I had to reset my laptop to the factory setting and lost this function.
ANY help would be greatly appreciated... thanks.
Hex, I was having the same issue, and after a couple hours of troubleshooting, I finally figured out that my specific BT drivers (BlueSoleil) on my PC require that BT DUN be on COM12. I was trying to dial out on COM9. Once I made my default connection COM12, I was good to go. Let me know if this helps or if you need some more help.
St. Pete 111, thanks for the info. I tried to change to the open COM12, but no luck. I have an IBM X60S with Broadcom chip. anyone who knows the correct COM, please let me know... how did you figure out that BT DUN had to be on COM12?
I originally installed the BCHS_FOR_POCKET_PC_OZONE.ARMV4.CAB file but now I'm trying to Sync with bluetooth and have had some odd microphone problems when bluetooth is enabled, I'd like to remove it.
Anybody know how? My Magician just sits and does the coloured spinning disc routine.
Your help greatly appreciated
Hi to everyone, I'm developing an Android application and I'd like to know if Bluetooth is currently in use = if one device is connected to my phone using a Bluetooth connection.
Thanks!!
If you find an answer to this,please let me know. I've been searching for about a month trying to figure out how to determine what blue tooth devices are connected when my app starts.
I'm looking into this myself. I'll keep you informed.
Hi,
After 4 months of good job ,the bluetooth PAN client function stopped working..
I have always used this function to connect my Leo to an Internet adsl pc.(via BT)
Also tried to join again the bluetooth pc with Leo....but did not work ....
So I ask you if you encontered this strange problem.
Maybe some registry settings damaged.....or something like that..
Shall I hard reset ??
Thanks ,regards
Hello
Now im trying to make a program to control my rc car with bluetooth of my Note 3
I just found that Note 3 dont have SPP profile and i cant comunicate with the bluetooth transmisor.
I dont know if it can be posible, but does anybody knows how can i do that? Does anybody knows if i can do that?
Thank u