hey people i have the same problem ...i followed the procedure that was givin above !!..but ..now too the problem is ooccuring..i mean sometimes the contact gets loose ..n i cant hear..but not as frequently as before..
now wat m thinking is SOLDERING A JUMPER WIRE BETWEEN THE SPRING AND THE CONTACTS wat say people...that will remove the problem forever !!!!
any comments?
please reply
Related
Hello people
I have an O2 XDA II mini running in WM2003SE..I installed INESoft Address book n was monkying in that..suddenly my SPEAKER WENT OFF..i am not getting ringtone nor can i hear to music..but i am able to hear music from my HEADPHONES..
I even HARD RESET my pda but for no use.when I PRESS NEAR THE SPEAKER..I CAN HEAR THE VOLUME..but when i leave it..it goes off.
PLZ HELP ME.I DONNO WHAT TO DO.I APPLIED LOAN TO TAKE THIS PDA..n its not yet cleared..
My FATE..It all happened..
PLZ HELP ME.I AM VERY DESPERATE....
Sathya
Take it to service center..
i am in india n there is no sevice center here in india.i have to send it to singapore which is nearest.
Usually these symptoms mean the little speaker has had its contacts bent. I had the exact same thing happen, and it was fixed by opening the entire phone and straightening them out. Havn't had the problem since.
Here's a guide if you're keen enough: http://forum.xda-developers.com/showthread.php?t=234650
I had a very similar problem with the speakers as well, all i did was put the volume right up to its max and played some music and within about 10 mins they were working again.
Thank u for replying me..i will try it out..n inform u people.thanks once again for ur support.
Sathya
EDIT:I tried palying songs continually for more than 10 mins with full volume but for no use
Sathya,
Its more likely that your device still thinks the headphones are plugged in and redirects all sound to that pin. This happened to my Magician, especially after removing the headphones after use.
I read somewhere in here, that if you plug-in the headphones, and instead of pulling them out softly, just yank them out, that way the loose contacts or whatever is causing the problem will set right.
It worked for me and hope it does for you.
As for service centres, there are atleast 5 authorised centres in India and scores of Un-authorised centres . Where are you located, I can post some known centres addresses .
Let us know if this works.
Thank u people...for ur support..
My speakers went to dogs..i got new speakers n my PDA is fine now.
Thank u once again.
Sathya
hi all
i am going to ask you all a vry wierd question.i am having problems with my ppc like it hangs n stuff even after a hard reset...dunno y this is happening all of a sudden but wenevr i take this darn thing to the service centre it works perfectly fine bt bak at home it is irritating me to the core.
can i do sumthin with it that it hangs in front of the service centre guys so that i can either hav a replacement or money back to buy another ppc.
plz plz help me on this issue
Hello Friends,
I have some small problems with my imate jam..its lyk,my phone switches off every five minutes no mater the battery it has..also..i hear to 10 audio every day..and talk about 20 minutes..by this usage,the battery drains out fully..i have doubt that,if i change the battery,will this problem of restarting be resolved?..or is it a internal hardware error?,yes the back panel is intact..and tight.
i figure out that its the battery problem..but i need some help..by the experiences.is this problem due to battery?..because,when connected to pc,it works fine..(hope,there is no hardware fault here)
also,I see that,as the phone drops(once), the phone had a reset..is this normal???
Thanks My friends!!
Sean
ok people..atleast reply...battery problem..or sum other....please..it is really importnt and urgent as i was planning to sell it off based oin the problem
cmon man..rather than reading..Why dont you post your experience.
Hi Sean,
Sorry for a slow response, but the rule here is search and then ask!
Anyways, according to your previous posts it seems that there is a problem with your device battery. Consider replacing the battery with a new one. It will hopefully rectify your problem.
Yeah. When a Magician drops, it generally goes to a reset. Thanks to the anti-shock mechanism.
Thanx for the suggesstion,yes im not new to this forum..i searched the forum,but cudnt find a similar post ..(well answered)...and i m realy thankful for your reply..Than ..Sean
try switching ur battery wid a friend whose havin a same model as urs....as far as i think...its a battery problem.
hey bro !!
i got this imate jasjar 2 years back and i love my uni allot.
need a help from you bro...i am new to all these hav been goin through 100z of threads everyday bt not gettin my answers i hope you would help me out..!!
actually my jasjar suddenly started behavin weird it switched off by itself n wen i switched it back on after the windows mobile screen shows up my jasjar gets a dead blue screen n nothin happens.
tried to connect with active sync 4.0 and 4.1 bt it would not respond and show dat the phone is not connected.
i came across a thread in which a guy said to press bright light button + power button+softreset it sent my phone to a usb mode
then i used mtty tool and its command task 28 to check if my jasjar is wasted or still breathin lucky enough it dint give a formatfaliure msg and there were some steps i followed .
everything went as told n now m stuck on where to get official wm5 for jasjar and how to get out of the usb screen and how to flash the rom...??
please help
To exit boot loader mode: http://wiki.xda-developers.com/index.php?pagename=Uni_Stuck_Bootloader
With regard to restorig WM5 - I have the official O2 XDA Exec files for their last software release. But I think you said your's is an iMate.You could see if the iMate version listed here: http://wiki.xda-developers.com/index.php?pagename=Universal_Upgrades is still available - if not maybe someone has a copy somewhere.
Hope this helps.
hey dat was gr8 bro....bt m still stuck with finding of wm5 for my imate ...!!
i found i mate upgrade bt when i clicked on download an error popped up "550 or 505 change of directory sumthin..."
well i followed the instructions u sent me it worked well bt still need to flash with wm5 ...!!
any chance of u or ur known havin a copy of wm5 rom
its been weeks and everything is gettin hazy ur help would be appriciated allot
thank you so much ..<!!
bro thankx for help i actually flashed my uni with kdskamal cooked wm5 bt my jasjar still gets dead on a greenish screen as it used to get before in blue screen wht m i supposed to do...??
Hi,
Try flashing with a WM6 rom (Tomal's ROMs are always good) and see if you get the same symptoms.
If you do then I suspect that you have a screen/cable connecting screen problem.
But lets rule out software first.
greetings bro...!!
i was up all night flashing wms
i used mtty software so many times that its commands are like hard weird in my brain cant get them out now....lolzzz
my stubborn uni was still stuck on the same dead screen but the only fun thing was that every time i flashed a new wm it used to get stuck on diff colours blue red green black...lolzzz
i scratched my head and i scratched my ass to an extent that i guess it started thinking lolzzz
i got some nice screw drivers and opened up my uni..
damn dis thing is wicked and messy it has things dat i dont know about n havnt even dreamd of in my stupidest dream i hav been lost in a computer motherboard with some good virus as my friend n some bad scary virus but in my uni motherboard i would neva..!
so i just fixed it back...n it worked for a while n den i dont know what tickled its ass.
busted again...!!
i guess ill hit the HTC service centre.
thanx allot bro
respect for ur effort and help...
Hi
for some strange reason the option "incoming com port" in the blue-tooth setting on my jasjar has disappeared. i was wondering if anyone else faced the same problem or if there is a way around it? editing registry n stuff.
because of this the previously paired devices are working fine but the new devices are unable to search the serial/com port facility on my uni.
i have tried resetting but still no luck.
any suggestions?
also i would really appreciate if someone could give me a solution for reading arabic and other such languages on uni.
(btw i am using i.e.TML 8.5 Rom and when i installed it at first the functionality was present so it cant be a ROM issue.)
...
lol... sorry abt earlier maite! i just realized the ridiculous thing i just did. i was supposed to post the reply to ur prob and then start with my sad story but somhow i managed to skip step one .
i m not expert on the device but i like it very much so i when i got one with my o2 contract i bought another one sim free just so that one would keep other company. as far as ur issue goes i have faced almost the same prob in the past and the solution was
1) rotate the screen 90 to get acess to screws at the bottom of the screen.
2) open the screws screws ... btw u might wana check if they are properly fastend before you try this step as i observed that if the screws are properly tightened this problem may solve itself... carrying on open the screws and that would detach the screen from the hinges.
3) where the hinge comes off strip open the cover a little bit and you will see two connections, one for the backlight and one for display (just like any other LCD screen.
4) press the big grip like thingee i.e. display connector with a flathead screw driver to assure they are properly in place. because in my case the connector had come off and hence was causing the system crash. although in my case the screen was only going blue after a while not the whole color palette.
just try if this one works because i m not sure if imate people are going to be any help in this case. i tried calling them a few months back for the lenscover and they said they dont support this device any more :S.
Can somebody plz tell me y my diamond's screen is always shaking when i turn it on n keeps shaking until i go to standby means turn screen off n thn resume! it shakes like "intrupted transmission" on tv!
Can sumbdy tell me whats the problem n wht cn i do to solve it! thanksss!
maybe you have parkinson.
LoL that's so true. . ever thought about that?
i have the same problem.....try to increase the backlighte
smx11 n natebentham with all d.u respect F**K u!!!! thnx 4 help tartosianoooo!
You have the wrong HardSPL. Try a different version from Olinex.
Touchpad problem...
You live on a fault line?
erhanakt said:
Touchpad problem...
Click to expand...
Click to collapse
How sz dis a touchpad problm bro??
Solved!!!!!!!!!! It wz really a hspl problem! came back to stock n its fixd nw!! nw i cn enjoye my boot animation lol!
zain rizvi said:
Solved!!!!!!!!!! It wz really a hspl problem! came back to stock n its fixd nw!! nw i cn enjoye my boot animation lol!
Click to expand...
Click to collapse
As I told you!
this is not the problem of light, instead there is a jack on the inner side of the motherboard when it gets loose the problem of flickring/ shaking occurs
go to the service center and tell him to replug the jack or you can mail me for the assembling and dissassembling video of diamod
you can solved this problem by installing diamond slide to answer.believe me.my problem solved after installing this application
shaanagrawal said:
this is not the problem of light, instead there is a jack on the inner side of the motherboard when it gets loose the problem of flickring/ shaking occurs
go to the service center and tell him to replug the jack or you can mail me for the assembling and dissassembling video of diamod
Click to expand...
Click to collapse
My brother u didnt undrstand wht da problem wz, it wz bcz of wrong HSPL!!!
laser21 said:
As I told you!
Click to expand...
Click to collapse
Yeah THANKS ALOT BROH!!!