gprs settings needed for mda2 (telfort)
Related
Dear all,
I've upgraded my MDA II with ROM WM5 (full RAM version), everything is OK. To connect to my ISP via GPRS, i've created GPRS connection, but I dont see 'Proxy Server' tab as I did with WM2003SE. My ISP use proxy to connect to internet, so that I could'nt connect to internet via GPRS from my MDA. How can I do? Everyone help me,pls!
Thanks
When I try to connect to GPRS at my Qtek 9000, the following message appears at the screen: "Cannot connect. Dialed: internet.mts.ru No moden at above number. To check your connection settings and change them if needed, tap settings." The settings are right. Another Qtek 9000 with the same settings and with the same SIM connects to GPRS with out any problems. How can I repair it?
Hi there
I have used Pof's instructions to configure my TyTn to not launch a GPRS connection if WiFi is enable... but how do you change the default from GPRS to WiFi is both are established already..
In the manual it clearly states that it will default to GPRS... is there a reg hack for this?
thanks
Is there a way I can disable the GPRS on my HTC TyTN? I would like to use the WiFi I have at home sometimes and it just automatically use the 3G, GPRS setting...especially with Internet Explorer which is on the phone.
Any help is appreciated...thanks!
I'm having this problem too. Whenever Wifi and GPRS are both active, it always defaults to GPRS. I cannot get it to recognise the Wifi connection under any circumstances.
I have an Orange SPV M3100 (HTC Hermes) with Windows Mobile 6.
sorry for my english first. if you use the automatic set up connection GPRS for your operator ; the wifi doesn't work.
You must do a hard reset and configure the GPRS connection manual.
Then the wifi works.
I've done this. I had to input my operators settings when I upgraded to Windows Mobile 6. It still doesn't work.
i installed wm6.1 opper on my t-mobile dash but there is a networking prob with the gprs, it doesnt recieve the gprs /internet data plan that i have for it
tried to put in the settings manualy`?
i got it put in gprs in the gprs setting under connections so i guess it can connect to the gprs in the gprs edge connection but just shows that theres a channel not that its connected