Hi how can i find what com port is been used
with my TOMTOM3
i am useing the Connect on BT GPS
Related
Hello all.
I have some problems connecting my Bluetooth handsfree to my Qtek 2020, so I installed Bluetooth Tools, and it works fine, but now I want to connect my Bluetooth GPS to use with Navigon 2005 and TomTom 5, but when I connect it I only see com port 7, and none of my navigation programs see com port 7.
What can I doo to fix this?
Hello all.
I have some problems connecting my Bluetooth handsfree to my Qtek 2020, so I installed Bluetooth Tools, and it works fine, but now I want to connect my Bluetooth GPS to use with Navigon 2005 and TomTom 5, but when I connect it I only see com port 7, and none of my navigation programs see com port 7.
What can I doo to fix this?
have tomtom 6, can pair my bluetooth gps and works ok but when i switch my bluetooth reciver off and on again for next use, tomtom dont see it any more i have to delete gps and re-add it then set up again in tomtom any one any ideas.
gps setup to com port 7 secure on ( also tested off)...
Hi,
Is it possible to have, say a bluetooth gps and a wireless stereo headset connected at the same time in WM6?
Thanks
Yep
I use a GPS and a bluetooth mono headset at the same time, so there should be very little difference, as one uses a serial port and the other uses the audio gateway.
also i think its possible to have two apps using gps if needed, for example tomtom and cameraware. You have to use the enable gps icon tweak and you then can set a hardware com port and software com port.
Does someone knows how I could activate bluetooth com(0) ,com(1) , com(2)
Thank you