hi,
After installing custom rom .35 whenever i restart or boot phone. it goes in FASTBOOT mode.
i need to press start button to boot in phone. it works normally.
Well i have twrp recovery.
help me guys. so phone starts normally.
Hi,
I did a TWRP wipe (everything checked) to prepare for a restore to stock, but my device is now stuck at the very first "Google" screen with the pad lock icon at the bottom. How do I get it to boot?
goister said:
Hi,
I did a TWRP wipe (everything checked) to prepare for a restore to stock, but my device is now stuck at the very first "Google" screen with the pad lock icon at the bottom. How do I get it to boot?
Click to expand...
Click to collapse
So since everything was checked, that means you wiped the system partition. The device will not boot if you do that unless you flash a factory image via fastboot or new ROM via TWRP
OK, I thought wiping /system would just bring it back to factory state. 2 questions now
1. How do I get to recovery when it's always stuck at the Google screen with no adb access? Would I have to wait for the battery to run out (hence turn off), charge it for a while, then use the buttons to boot to recovery, or is there a faster way?
2. I am actually trying to revert to stock ROM (downloaded at https://developers.google.com/android/images#angler) by following step 10 of the Heisenburg guide (https://forum.xda-developers.com/nexus-6p/general/guides-how-to-guides-beginners-t3206928) which advises me to use fastboot to flash the individual images. In my case, how do I boot to fastboot?
OK, so I managed to boot to the bootloader and run the following commands as per the Heisenberg guide (using the stock MTC20L firmware)
Code:
fastboot flash bootloader C:\angler\images\bootloader-angler-angler-xx.xx.img
fastboot reboot-bootloader
fastboot flash radio C:\angler\images\radio-angler-angler-xx.xx.img
fastboot reboot-bootloader
fastboot flash boot C:\angler\images\boot.img
fastboot erase cache
(above command is unnecessary on Android 7.1.2 and above)
fastboot flash cache C:\angler\images\cache.img
(above command is unnecessary on Android 7.1.2 and above)
fastboot flash recovery C:\angler\images\recovery.img
fastboot flash system C:\angler\images\system.img
fastboot flash vendor C:\angler\images\vendor.img
Everything was successful, and I did a fastboot reboot after that.
However, my device still doesn't boot up. This time. It's boot loops for a few times before turning off.
I tried booting up to bootloader with power/vol-. Curiously, I can now only do this when cable is connected. If cable is disconnected, the orange LED just blinks once when power button is pressed, and nothing happens. Once cable is connected, then I'm able to boot up to bootloader with the button combination. I then retried the flash process again, but still no go. I noticed after fastboot reboot that the orange LED blinked a few times before rebooting and boot looping.
Kinda stuck now, any ideas?
Try booting into recovery and doing a factory reset. I've had that happen to me a few times after flashing factory images and a wipe in recovery always fixed it.
Just for future information: if at any time the device is stuck in a bootloop you can get it to robot into recovery by holding the power and volume down buttons for 10 seconds, or get it to boot into bootloader by holding power and volume up buttons for 10 seconds.
Face_Plant said:
Try booting into recovery and doing a factory reset. I've had that happen to me a few times after flashing factory images and a wipe in recovery always fixed it.
Just for future information: if at any time the device is stuck in a bootloop you can get it to robot into recovery by holding the power and volume down buttons for 10 seconds, or get it to boot into bootloader by holding power and volume up buttons for 10 seconds.
Click to expand...
Click to collapse
Thanks. Booting into stock recovery shows an exclamation sign with "no command", since I don't have TWRP anymore. Would I need to first flash TWRP before I can do a factory reset?
I just tried flashing to the same sock firmware as before the problem happened (7.1.2 N2G47W) but still same problem. I notice that after the Google logo disappears and the screen goes blank, the orange LED blinks 10 times before rebooting.
Edit: Tried factory resetting in stock recovery (by holding down power button and pressing vol+), the rebooting after factory reset. Still getting a boot loop.
OK I solved the problem. Apparently if you reboot after the flash, you need to disconnect the USB cable, else it will boot loop.
OK I solved the problem. Apparently if you reboot after the flash, you need to disconnect the USB cable, else it will boot loop.
goister said:
OK I solved the problem. Apparently if you reboot after the flash, you need to disconnect the USB cable, else it will boot loop.
Click to expand...
Click to collapse
brother help me! i am facing same issue
first little info abt my device.
my device was running on android nougat with twrp recovery installed but the device was not rooted.
so get back to stock and install oreo I followed every step given on http://www.androidexplained.com/nexus-6p-revert-stock/ but somehow my phone is stuck at bootloop with no recovery installed.
Please help me here.
As per the Heisenberg guide, if you don't install root (SuperSU or Magisk), TWRP won't stick, so you'll go back to stock recovery.
For me, simply unplugging the USB cable after rebooting after a flash solved my problem. For some reason, if the cable is connected during reboot, it would boot loop.
brother, somehow I managed to install twrp. but everytime I touch it 2-3 times the phone gets switched off.
then it keeps rebooting to 'Google' logo.
can you tell me what should I do now?
@goister Hi how you manage to get to recovery when it's always stuck at the Google screen with no adb access. Please I am stuck there
tommast said:
@goister Hi how you manage to get to recovery when it's always stuck at the Google screen with no adb access. Please I am stuck there
Click to expand...
Click to collapse
hi, did youmanage to solve this problem? I am aving the exct same problem. Disconnecting the ucb isnt working for me
Hi,
I had installed Viper OS but then the phone got stuck in bootloop and when I try to go to recovery it just takes me to the fastboot mode. I am unable to go into recovery even with power+vol up. I tried to install new rom with MiFlash but when I do it, it just shows complete in a second and when I try to restart the device it get stuck in bootloop again. What should I do ?
Try Power + Vol+ + Vol-
Anyone seen issue when they enter recovery or fastboot, starts recovery or fastboot and then boots after 30 seconds no matter what I try. I need to figure out how to make it not automatically boot.
Thought issue might be the preloader?
Hello i need help please.
I was trying to flash twrp using adb and fastboot when i accidentally flash aboot.img into system and now it wont boot into the system and it stuck on lg logo and it wont let me boot into recovery mode. When i do the Vol. down + power it directs me to factory data reset and I tried resetting it and gave me an error "Your device is corrupt. It can't be trusted and may not work properly."
Does anybody know how to fix this issue please?.