Hi,
I'm selling my S5 so I need to remove the ROM that installed from this thread:
http://forum.xda-developers.com/showthread.php?t=2732110
and return to stock. Can someone point me to instructions for this process?
Thanks.
Stock ROM for the model number of your device
Odin3 tool.
Samsung Kies or Samsung mobile driver.
Charged rooted or non rooted Samsung galaxy S5.
USB cable and Windows PC
Backup your important data before flashing, in case of this process corrupt your data. [important in downgrading] Download stock ROM file (make sure you download the right FW for your phone's model number) from SamMobile or Samsung-Updates and unzip it only one time (the extracted firmware file has *.tar.md5 extension). Download and install Samsung Kies or Samsung mobile driver (Link below) Download Odin3 tool and unzip it (Link below) Close Samsung Kies and disconnect any device connected to USB ports of your computer.
Run "Odin3" as administrator.
Click on PDA button (AP if you are using Odin3 v3.09) and navigate to the *.tar or *.tar.md5 firmware file (it will take a few second to check firmware file, if you are using Odin3 v3.09).
- If the Zip file contains more than one *.tar file then they will be labeled with PDA, Phone and CSC. Put them in the corresponding section of Odin3
Shut down your device and make sure it's completely off. Put your device into download mode by pressing and holding (Volume Down + Home + Power) buttons then Press Volume up to continue.
Connect your galaxy S5 to PC using USB cable and wait until you get a sign in Odin (ID:COM section) and "Added" in message box. Make sure re-partition is NOT MARKED[very important]
Click Start and wait a few minutes until you see "RESET" or "PASS!".
If your device stuck in bootloop, factory reset it from recovery mode.
Instructions were taken from wolfdroid, i followed them an installed the stock rom on my s5.
Hello everyone
I have a g900f from UAE and as it still hasn't got lollipop I was wondering if I can flash another firmware from sammobile.. If I can do so, can someone guide me at how to do it?
Sent from my SM-G900F using XDA Free mobile app
Yep, long as it's for the G900F
Grab ODIN, grab the ROM you want from sammobile, install samsung drivers, put the phone into download mode, connect to PC, press PDA or AP on ODIN and load the .TAR ROM file, press Start
Phone will be wiped in the process so backup anything important
Instructions are under the download on sammobile anyway
Instructions
Extract (unzip) the firmware file
Download Odin v3.09
Extract Odin ZIP file
Open Odin v.3.09
Reboot Phone in Download Mode (press and hold Home + Power + Volume Down buttons)
Connect phone and wait until you get a blue sign in Odin
Add the firmware file to AP / PDA
Make sure re-partition is NOT ticked
Click the start button, sit back and wait few minutes
I need helps to unbrick my i9505
Before ,phone was on Android 5.0.1
& Base band OHD7
After an wipe all data
I get this screenshot &
phone is not recognize by pc
I have download mode but
i cant obtain recovery mode
Bigs Thanks for all replies.
Download from Sammobile the firmware for your model and country,put the phone in download mode en flash the firmware with Odin and all should be fine
Bigs thanks for answering
I will tray but not with big conviction
Because phone in download mode
is not detected by pc
I will test other pcs & other cables
Thanks very much
Two days ago i had the same issue and i tried on Windows Vista and on Windiws 10,no succes. Succes on Windows 7.
Do you have KIES on your pc? If not download Kies,it will install the nesesarry drivers on your pc.
hi , ludoke
i tried 2nd time with another laptop :
Now my phone is detected by pc on download mode it work on win7
i flash firmware but
i get FAIL with notification there is no partition : attached screenshot
Always no recovery mode and normal reboot give screen get issue with pc <-------->phone
i will try with kies
thanks for encouragements & helps
Then you have to search for firmware with Pit. file and CSC and Modem, Firmware files and flash with Odin ,repartition ticked.
Search or ask here on XDA, i can't help you with that
Did you unpack the firmware zipfile once ? Don't flash the zip file and do NOT tick repartition if you have just 1 file(tar)
Different usb port/ make sure you flash not an old firmware when you are on the knox bootloader.
Hi , Lennyz1988 & Kudoke
Before sofbrick phone was android v5.0.1 & Base band OHD7
I tried flash firmware XXUHOA7 with pit on odin 3.10.6
But i get FAIL attached screenshot on #1
i will test with other odin versions & other pc always win7
kind regards
In howmany files was that firmware ? Firmware from Sammobile has mostly 1 file in the zip,so my advice is to download firmware from Sammobile for your model and country,unpack the zipfile once and you get two files . Go to download mode.
Flash the biggest file in the AP box in Odin and do NOT thick repartition. Use Odin 3.09
Also,use usb 2 port
Lastly i success the flash
I get this far
for that i have reinstalled new Os windows 7 on laptop
i use odin 3.09 and the same firmware XXUHOA7 with 4 files no pit
miraculous thing : green PASS , attached screenshot on #1
i have average fifties flashs sucess & a dozen different devices rooted
but this one make me very happy
I hope that noobs friends share & take advantage of my modest experience in 3 days
Thousand thanks for Ludoke & Lennyz1988.
BEFORE MY PHONE RUNNING ON XSI 5.0 FIRMWARE
AND NOW BY THIS PROCEDURE
SUCCESFUL TO INSTALL BRI 5.0
THIS IS FOR MISMATCH CATCH.IMG.EXT4
ODIN FAIL WHO TRY IT
FOR FLASH WTH HONGKONG TAIWAT FIRMWAE 5.0 WORKING THIS PIT
FIRST U DOWNLOAD
N9005ZSUGOK2 N9005OZSGOK2 N9005ZSUGOK2 FROM SAMMOBILE
THEN DOWNLOAD PIT FILE GIVEN LINK
then download Odin_v3.09
select pit
pad tab select firmware
before connect phone enable usb debugging
then connect phone with download mode
FLASH FIRMWARE
WAIT 5 MINUTE YOUR PHONE STUCK IN BOOT
MUST CWM RECOVERY n9005-cwm-recovery-6.0.4.7-kk(0125) COMPALSARY FLASH
NOW REMOVE BATTERY AND INSERT IT AGAIN
AND GO IN DOWNLOAD MODE
THEN DOWNLOAD CWM RECOVERY FILE GIVEN LINK
CWM RECOVERY.TAR UNDER PDA TAB AND FLASH IT
THEN YOUR PHONE START IN NORMAL BOOT AND EVERYTHING WORKING PERFECTLY
First I will like to say thanks to @dr.ketan for providing us the BL and Modem from N920G to allow the install of MM on our devices. Now that the BL & Modem is out for our device, this will just be quick How-To revert back to N920I from N920G without flashing stock download. The purpose for this is to revert just the BL & Modem to stock conditions created by Samsung for the N920I without having to completely flash back to stock.
NOTE : This WILL replace the BL, Modem, and Recovery on the device.
Recovery included is TWRP (twrp-3.0.2-1-noblelte.img)
1. Download N920I_BL_Modem_Recovery.zip - MEGA
2. Extract allfiles.tar.md5 from .zip
3. Place phone in download mode (Shutdown device - Hold Vol down, Home, and Power until Warning appears)
4. Download/Launch Odin3 v3.10.7
5. Select AP in ODIN and navigate to downloaded file (allfiles.tar.md5)
6. Deselect Auto-Reboot
7. Start
8. Force restart (Hold Vol down + Power) - Alternatively you can restart into recovery mode if wanted/needed
Done.
Disclaimer:
Please know/remember that I will not be held accountable for any bricks or malfunctions of the device, software, and or products needed to perform this.
With that said I have personally have tested this on my device running RiverRom without any issues.
BL & Modem extracted from N920IDVU2BPD3_N920IOLC2BPD3_N920IDVU2BPC4
Thanks :
@mkh.mourad for [Script][Tool] how to create a tar.md5 file from img For Odin
TeamWIN for TWRP