[Q] Kindle Fire turns off after plugged into USB - Kindle Fire General

Hi,
I think i really messed up my KF this time...
After i bricked my KF with editing the framework-res.apk, I got stuck on the boot loop....
And without TWRP it was impossible to restore my Kindle Fire, so i got the idea to use a Factory Cable to restore it back again....
However, now with plugged Factory Cable /normal USB Cable, the Kindle will turn off the screen automatically and Windows won´t recognize the device anymore?
If I don´t plug any Usb Cable on the device, the KF will turn on normally and get stuck in the boot loop...
Any ideas?
Update: For some reason, the KF will turn on with the Factory Cable but logo 'kindle fire' won´t make any animations....

Related

[Q] Bricked!

So i may have bricked my Kindle Fire. I rooted it successfully, did not install TWRP or anything similar. Installed the Android Market but could not get it to work so i "deleted from device" from my carousel and my Kindle turned off and couldnt turn back on Then I attempted the Kindle Unbrick Tool and tried that, but it seemed that it could not find my Kindle on my computer (I'm running windows vista) Even when i plug in the usb it doesnt make the happy little noise it makes when you plug in something. I went to device manager and saw that it was recognizing it both as "Android" and under portable devices, "Kindle" or a few times it came up as "L" which is the usb port I had it plugged into.
tldr; Unbricking tool is not "finding" my Kindle on my computer Also I'm kind of a n00b at this, as far as running codes and whatnot.
side note: My kindle is also low on battery at the moment. I have it charging right now, so maybe that's a factor?. When I turn it on, I get the Kindle fire logo but no animation, it still stays lit after that screen as if it's still on but nothing happens..Any advice would be appreciated ^.^
Hey, My kindle got stuck in fastboot too. It wasnt recognized by KFU and unbricking tool. Here is how I managed to recover to normal boot: Remove the drivers in device manager and reboot your stuck kindle fire, but do not unplug it (just hold power button for pretty long time till it shuts down, then just turn it on). Windows should recognize some device. now install adb drivers and launch KFU. If it sees your fire you are good to go, if not just try changing bootmode to 4000 as if it was recognized. BUT this worked for me. I do not know if it will work for you! I take no responsibility or whatsoever. Good luck sir. Do not give up

[Q] Stuck on FireFireFire logo slightly diffrent problem

So after reading and trying how others on here fixed that very same problem I deiced its time to make a post and ask for help because those other methods did not work.
Ok I did something stupid and I went ahead and did a factory reset to my kindle. Yes I know it was a complete noob thing to do and I should have known better seeing that I have rooted and flashed ROMs on all my other android devices and never once did something that dumb but I did it this time. Now I do have a back up made and had it safely stored on my PC.
Problem is that I can't get into recovery it stuck on the FFF logo and holding down the button only brings it back up. When the device restarts windows recognizes it as an unknown usb device and won't connect and Adb also wont recognize the device or show that it is connected. So now I need to ask someone who is more knowledgeable then me on what to do next. Any help will be appreciated
Ok update: Was able to solve my own problem using the Kindle fire utility and by uninstalling the drive for the kindle through the device manager, then using the drive install_drivers.bat in the KFU folder to reinstall the drivers. I next unplugged my kindle from the pc, turned it off by holding the button on the kindle in and then restarted it with the usb plugged into the pc. My Pc recognized my kindle and I was then able to use KFUs Bootmode menu and once in there used option 1. to boot it in normal mode. Hope this helps anyone who was stuck like I was. My memory of which adb commands to use was a bit rusty but using the KFU helped with that part.

[help] kindle fire stuck at yellow triangle/reboot loop

Hi, I've recently rooted my Kindle Fire device using KFU v9.3. After this, I noticed that FFF and TWRP weren't installed. So I used KFU to install FFF and it worked perfectly. I tried to install TWRP and it failed saying
"Oops… something went wrong with the download.
The recovery downloaded is not correct.
Please try the download again."
However, on the second try it worked up until a point where KFU said "Setting Normal bootmode" followed by "waiting for device...". This was when my kindle got stuck on the yellow triangle screen and my computer has not been able to recognize it since.
I have tried to install drivers via the install_drivers.bat file in KFU, however i get the error "install failed (Unsigned)" I tried to use Zombiepirates' Kindle Fire Unbrick Utility and selected "Stuck at logo" but it can't find the device.
Now when I plug my kindle into the computer it just keeps turning on and off and my computer doesn't recognize it.
I'm using a WIndows XP pc and I have access to a windows 7 one if needed.
Try this..
http://forum.xda-developers.com/showthread.php?t=1422832
Have you tried using KFU to change the bootmode back to normal despite your kindle not being detected? After you attempt to change the bootmode to normal perform a hard reset (hold the power button for 30 seconds) and your kindle should be detected. Hope this helps, worked for me for the same issue
I can't, whenever I use "install_drivers.bat" I get an error that says "Install failed (Unsigned)"
Do you know how I should go about fixing this?
BluesHawk said:
Have you tried using KFU to change the bootmode back to normal despite your kindle not being detected? After you attempt to change the bootmode to normal perform a hard reset (hold the power button for 30 seconds) and your kindle should be detected. Hope this helps, worked for me for the same issue
Click to expand...
Click to collapse
Yes I have. It says "waiting for device" and I did a hard reset to my Kindle but still it's "waiting for device" now my Kindle is just shutting on and off rapidly whenever it's plugged into the computer
Is windows blocking the driver? You're on XP right? Try this, then try installing the driver.
Right click on My Computer then select Properties to open System Properties.
In “System Properties” dialog box, select the Hardware tab.
Click on Driver Signing button.
Make sure "block" option isnt checked. That wouldn't let you install any uncertified drivers.
BllgpapaG said:
Yes I have. It says "waiting for device" and I did a hard reset to my Kindle but still it's "waiting for device" now my Kindle is just shutting on and off rapidly whenever it's plugged into the computer
Click to expand...
Click to collapse
The same thing is happening to me. My kindle is rebooting when plugged into the computer, KFU or KUU aren't able to do anything. I'm using Windows 7 but I can't bring up the drivers because the device isn't recognized by windows
any ideas on how to stop this rapid rebooting is much appreciated
Edit
a link to my post on a similar issue can be found here
MasterJoefus said:
The same thing is happening to me. My kindle is rebooting when plugged into the computer, KFU or KUU aren't able to do anything. I'm using Windows 7 but I can't bring up the drivers because the device isn't recognized by windows
any ideas on how to stop this rapid rebooting is much appreciated
Click to expand...
Click to collapse
Update your kindle fire driver with the file in the KFU directory.
Go into Device Manager, find the Kindle fire, update the driver and point it to the driver in the KFU directory. (KFU>drivers>kindle)
_Justin said:
Update your kindle fire driver with the file in the KFU directory.
Go into Device Manager, find the Kindle fire, update the driver and point it to the driver in the KFU directory. (KFU>drivers>kindle)
Click to expand...
Click to collapse
The kindle is not listed in the device manager because after the kindle reboots a few times while connected to the pc, windows stops adding it to the device manager. Is there any way to manually add it and add the drivers?
MasterJoefus said:
The kindle is not listed in the device manager because after the kindle reboots a few times while connected to the pc, windows stops adding it to the device manager. Is there any way to manually add it and add the drivers?
Click to expand...
Click to collapse
I don't know why it's doing that. Is it constantly rebooting? Try another USB port or PC.
from the op of kfu:
Known Tricks
•If you end up stuck at the yellow triangle, in KF Utility select Boot Normal, wait for it to say <waiting for device> and then press and hold the power button 20 seconds until the fire turns off, then when its off turn it back on. This sometimes happens, I have yet to find a clean solution
•If you end up stuck with a yellow triangle, do not EVER unplug it. Leave it plugged in. Check the windows drivers to make sure it isnt showing as "kindle" again. Fastboot is different and can cause this.
Click to expand...
Click to collapse
and from vashypooh - dev of kfu:
http://forum.xda-developers.com/showpost.php?p=20945694&postcount=506
about drivers:
http://forum.xda-developers.com/showpost.php?p=22342376&postcount=6
hope this helps ...
@b63
THANK YOU! Your post about drivers is the most direct and effective way to install drivers. I wish I could thank you a million times.
glad to help ...
please mark the subject of the topic (edit first post) with [Solved]
Kindle Fire in FFF Loop
I am also having the same issue as well. Tried running the KFU for unbricking and still nothing as my PC nor my laptop is able to recognize my KF. Not sure what to do. It is constantly just looping while connected via USB and if I disconnect it, it powers off.
Any help would be great.
sounds like empty battery
would try to charge it with the wall charger for some hours
if it turns on if you plug it to the wall charger try to power it off by holding the pwr button ~20sec till it turns off to allow charging
noob needs help with ice cream sandwitch gone wrong!!
Hey ya'll,
So I'm sure you're tired of noobs posting but I just need a little help. I rooted my kindle last night and then tried giving it ics 4. So, I wiped everything (as instructed) and before hand I added the cm09 file along with the gapps. Yet, when I downloaded and extracted these two files they came out as multiple files so I first extracted the files to my desktop. I then transferred the individual files to the root of my kindle. When trying to "install" them , the individual files(which cm09 and gapps had been comprised of ) popped up but I couldn't do anything with them (flash ,etc). So, then I tried condensing all the gapps files into one "gapps" folder and all the cmo9 files into one "cm09" folder and transfer it to the root. Same thing happened. What I think I should haev done is not extracted either and just have sent the unzipped files to the root of my kindle...woops...I am a dumb noob after all! So, now I'm stuck with my kindle and when I turn it on to "normal mode" (not the TWRP) the "kindlefire" insignia pops up at start up like normal but it just sits there like that. Any idea of what I should do and where I can get the files to do it so that I too can have the LIMITLESS POWER OF ICE CREAM!!?? MWAHAHAHAHA...really though..any help ?
would try to boot to twrp - tap mount and mount sdcard - copy the cm9 file to the root of sdcard as instructed - install it with twrp - that should do it
you can install the necessary gapps afterwards - if i remember right it is also described how to do in the op of cm9
i just wanted some help. I rooted my kindle fire and flashed everything had cm7 on it one point and wanted to try miui's rom. I did as instructed but its stuck on the fff screen. Ive also tried as b63 instructed. But every time i connect my kindle it shows up for a brief second and disappears. What do i do? Please help! thank you!
You are 100% correct.
b63 said:
sounds like empty battery
would try to charge it with the wall charger for some hours
if it turns on if you plug it to the wall charger try to power it off by holding the pwr button ~20sec till it turns off to allow charging
Click to expand...
Click to collapse
If the yellow triangle is flashing and the tablet turns of when you unplug it from your computer then the battery is totally dead. I figured that out after 7 hours of frustration!
Yea I had that same issue with mine. I connected it to its factory shipped charger and about an hour later it was turning on and staying on.
Sent from my Kindle Fire using Tapatalk

Please Help Me loop in cyanogen mod logo

Originally Posted by khrisjian
Please I have a similar problem, and these are the facts that I did
1. Root my kindle and install Cyanogenmod 9 (everything is fine for a while)
2. Unroot kindle and uninstall TWRP (mine stupidity) :/
3. I locked out my kindle after put bad patterns and worse not have wifi connection anymore
4. I tried to root again and again but the kindle restarts every time
5. Now my kindle after I connected to charger restarts 2 or 3 times then loop in cyanogenmod logo for ever and drains all battery (the logo is moving)
6. I tried to root once again but the FKU don't recognize
more facts
a. Everytime I connect my kindle to a PC the kindle power up and the pc it recognizes an usb mass storage but does not appear a drive
b. After install drivers (run install_drivers.bat) in a new PC then connect the kindle for first time the device manager appears a new device with name of "Galaxy" but then the pc it recognizes an usb mass storage but does not appear a drive
Please help I don't know how to do anymore
P.D. I'm so sorry for my bad bad english
Wow sounds like an ugly situation. You will very likely need a factory cable to force it into fastboot in order to Reflash twrp. What do you mean by uninstalled twrp can you provide more info on your steps? To resolve your driver issue you might want to first start with a live usb and soupkit http://forum.xda-developers.com/showthread.php?t=1850038 .
Thepooch said:
Wow sounds like an ugly situation. You will very likely need a factory cable to force it into fastboot in order to Reflash twrp. What do you mean by uninstalled twrp can you provide more info on your steps? To resolve your driver issue you might want to first start with a live usb and soupkit http://forum.xda-developers.com/showthread.php?t=1850038 .
Click to expand...
Click to collapse
I remember that removed the blue letters "Kindle Fire" from first boot logo and the option to get in to Recovery Mode hence to avoid entering there I don't remember how I did that

Rapidly connecting and disconnecting in USB Mode

When I connect Nook to computer the reader's screen starts flashing and I get many pop-ups that device was connected
but it almost immediately disconnects. I can successfully restore full memory backup using noogie but after booting I can't connect Nook to computer. Help!
PS. I tried another cable.

Categories

Resources