First up I'd like to point out that I'm fairly happy with what's going on. I've put more custom images on my Hero than you can shake a stick at
That being said I cannot for the life of me get my Streak to take a new image. I'm praying that someone can figure out what I've screwed up and point me in the right direction :/
A couple of days ago I successfully installed Steve's 1.1.1. I immediately upgraded that to 1.2.0 with the amss update too. At this point my Streak stopped booting, getting stuck at the Dell Logo :/ I've tried for the past couple of days to fix my situation, trying just about everything I can find on the site but nothing got me booting again.
So I went back to the 1.6 nandroid backup I'd made
However now when the Streak boots into 1.6 I have a couple of issues:
1) The Home and Menu icons flash/alternate occasionally.
2) I'm getting No Service AND my baseband is reported as unknown :/
The full details 1.6 reports are:
Baseband Version: Unknown
Kernel version: 2.6.29-perf
OEM version: GAUSB1A110700
Build number: 4399
As the Official 2.2 has been released I thought I'd try that. So following the guide I've applied it via fastboot but this just will not work either. I've tried 4 or 5 times now and after 15mins of sitting at the Dell logo I conclude it's failed.
Can anyone suggest anything I can try ? I'm guessing I've somehow screwed the combination of baseband and system image but I'm lost as to what I need to straighten it out :/
Ok, well after trying to recover what feels like a thousand different ways. I've managed to get an O2 1.6 image on, with an identifiable baseband version. I did this following the guide on modaco
So now I'm going to try for 2.2 again.
Hi
Unfortunately I've screwed up my Dell Streak when trying to update it. The baseband version is now set to 'unknown' and I'm a bit too scared to tinker further in case I completely ruin it.
I was previously on the following (attached image is current configuration):
UK O2 contract. 'Locked' to O2.
Firmware Version: 1.6
Baseband Version: GAUSB1A110421-EU
Build Number: 3883
I'm still able to Fastboot files on to it, and can copy files to the memory card. I've tried a few times to put it back to factory defaults, but with no success (doesn't seem to load Update.pkg from stock recovery menu, just goes to a black screen each time. Did previously have clockworkmod running on it).
Does anyone have any ideas how I should proceed as I'm now scared I'll brick it...
Thanks
Jez
I've since tried installing 'Official 2.2 Froyo Untouched' (hXXp://android.modaco.com/content/dell-streak-streak-modaco-com/323561/official-2-2-froyo-untouched) and it now hangs at the dell logo.
I've also just tried the 'Fix for - 'Stuck on Dell logo after 2.1 update' (O2 only)' (hXXp://android.modaco.com/content/dell-streak-streak-modaco-com/317263/fix-for-stuck-on-dell-logo-after-2-1-update-o2-only/) but it just hangs on a black screen when I run the update.pkg. Does anyone know how to get it working again?
My omnia 7 shuts down all the time.. i don't know what the issue is. I have hard reset the phone a couple of times.
It happens very often when charging. As soon as the screen turns off, 1 or 2 minutes later, it comes back on again, says "Goodbye" and phone swithces off and then restarts. I then have to insert the sim code again.
I had Mango installed and tried to turn off 3G in the diagnostics "app", by choosing GSM 800/1900 i think it was. It was then it started behaving weird, and restarting. I have since reverted it back to Automatic in the diagnostic window, gone back to NoDo, and done a hard reset.
Done some more testing. If the sim card is removed, all is normal. it charges, and everything is fine. As soon as sim card is inserted it starts shutting down all the time.
i have also tried having the sim card inserted, and click cancel when asked for sim. still it restarts.
will the diagnostic changes have been reverted once i hardreset?
Firmware revision number: 2424.10.11.1
hardware revision number: 3.15.0.4
radio software version: 2424.10.11.1
radio hardware version: 0.0.0.800
bootloader version: 4.11.0.3
chip soc version: 0.36.2.0
Have you try this : http://www.samsung.com/no/consumer/...NEE/index.idx?pagetype=prd_detail&tab=support
I had the same problem a few month ago. It seems that firmware upgrade have resolve the problem for me
Dear dada051. Thanks for reply.
I went to the link. But is it the "Kies" i should install, or the patch? the patch is for installing NoDo? I already have it installed. But my firmware might be old. I believe the new one is KC1? I have JK1 out of the box i believe. Please help me..
Forget the "Kies" software. You should install http://org.downloadcenter.samsung.com/downloadfile/ContentsFile.aspx?CDSite=UNI_NO&CttFileID=4048024&CDCttType=SW&ModelType=N&ModelName=GT-I8700&VPath=SW/201105/20110524101224996/Device_Update_Support_Tool_for_OMNIA7_KC3_Ver1.2.exe
(it's the direct link to the firmware updating software, v KC3)
If you use the first link i've post, you'll find the second link in the "Programvare" section
I have tried this now. It went to download mode, the program did something, and the phone restarted. Zune says that the software is up to date, as i have NoDo already. The firmware revision and radio version did not change. still the same as mentioned over.
Should i install a new ROM?
If you don't have the diagnosis app : dial ##634#
It create a link in your app list to disagnosis and launch it.
If you have the diagnosis app, launch it.
type *#1234# to display the firmware version
if it's not :
PDA: xxxxxxxKC1
Phone: xxxxxxxKB2
CSC: xxxxxxxxJK1
you have to install the ROM KC1 that you can find here http://www.samfirmware.com/WEBPROTECT-i8700.htm (you need to be registred).
You will find any help you need to update your firmware in this site. I can help you tomorow if you need.
THE FIRMWARE UPDATE WILL ERASE ALL DATAS IN YOUR PHONE!!
My Phone : KC1/KB2/JK1
Firwmware : 2424.11.3.1
Radio software : 2424.11.2.2
bootloader : 5.3.0.4
Ok. i have now flashed to KC1.
Firmware: 242411.3.1
Hardware: 3.15.0.4
Radio software: 2424.11.2.2
Bootloader 5.3.0.4
And the phone has finally settled.
I have installed mango beta again, and i am charging the phone right now, and since the flash yesterday, no shutdowns.
Love my new omnia 7. yesterday, i was about to throw it away and go back to my iPhone 4.
I noticed some varius bugs happeing after some short time after you bought the phone. Pulling the battery and letting it lay around a short while seems to fix it, and never returns again after that.
Wery strange, but not sure that would have helped you, just saying that wierd things seems to happen with new Omnia 7 phones that with battery removment seems to fix the most.
Could be the same issue i had. I also removed the battery, and then inserted the battery again, also hardreset and flashing of KC1 firmware. No longer sure what fixed the problem
megaoctane said:
Could be the same issue i had. I also removed the battery, and then inserted the battery again, also hardreset and flashing of KC1 firmware. No longer sure what fixed the problem
Click to expand...
Click to collapse
Kämpe flott when all can be fixed with battery removal: -)
Now in Swedish
Igår den 22:a blev ni ännu mer vår bror. Vet att norrmän har svårt med svenskar, men all sympati och kampvilja delas här. Vidrigt vad mänskligheten kan göra.
Thanks god, that I never had any problems with my omnia.
Just unboxed a Verizon Trophy today. Activated on the Network successfully.
Phone is running the following Windows Phone Version
OS Version: 7.0.7389.0
Firmware Revision Number: 2305.06.10322.605
Hardware Revision Number: 003
Radio Hardware Version: 1.52.00.03.28_23.15w.05.06U
Bootloader version: 1.3.230506.23
Chip SOC version: 2.3.0.5.6
The phone is saying no updates found.
Zune software did not update on initial connection.
When trying to manually update via Zune Software 4.8 the following error appears.
"Can't check for updates right now. Please try again later.
We couldn't connect to the update service. Disconnect and reconnect your phone, then try installing the update again.
80072EE7"
This error has occurred on three separate computers including a fresh install.
While this device is brand new it's no longer under warranty.
Any Ideas?
Verizon, HTC, and Microsoft have no clue whats going on.
Screw that, you have two options.
SPL hack, custom rom. Read my guide here to find out how!
Benefits:
Full unlock, run stuff like Opera!
Internet sharing enabled!
Download the newest rom and flash it. You won't lose any data since you have non to lose. Go to footballs thread here and get "RUU_Spark_W_S_VERIZON_WWE_2.04.605.02_Radio_NV_0215_NV58008_RELEASE.exe".
Sorry I didn't catch this thread earlier, but I hope this helps. I'd just do a full unlock. :/ Having the shipping rom and the 1.03 bootloader (you should), you should be able to unlock very easily.
Sorry, double post... lost internet during first post. Please delete.
Alright....
So I've gotten a new phone, and I intend on selling my AT&T GS5. Only problem with it is that it will not update. I had rooted it awhile back, I can't remember how I did (something rain comes to mind when I to remember). Anyways, I've factory reset it, and tried to load a complete stock rom onto it. It still won't update.... When I download the OTA update, it will begin to install and then at 28% it will say "Update failed" and then reboot the phone. Any help?
Model: SAMSUNG-SM-G900A
Android version: 4.4.2
Kernel Version 3.4.0-2178781
Build Number: KOT49H.G900AUCU2ANG3
As of right now the device is fully stock (freshly factory reset), even says "official".
Let me know what you need, thanks.
Make sure that your Build Number and Baseband Version match (last 3 being NG3)
Here's a similar post that I got that information from:
http://forum.xda-developers.com/showthread.php?t=1914786