*#0*# press that into your dialer when you press last # the screen will immediately come up. In there you can test led colors, vibrations and some other stuff.
Related
Hi guys,
When i want to call someone with the green button (call button), when i press it then the volume goes one down and the camera opens.
This is not all the time. But sometimes it happens and it verry anoing when u want to call someone.
So when i press the green button it doesnt call but opens the camera.
I did not install any software, but was changing some settings in su2. But i set it back.
Another thing is, when i press up whit the middel button it inserts #* instead going up.
how can i set these things right, instead hard reset
I used to have it so that if I held down the red (hang up) button, and picked no choices from the menu that comes up (lock, turn off screen, sleep, etc.), it would automatically become locked needing me to slide the slider next time I turned it on before it would take keyboard commands. I soft-reset it, and now that doesn't happen anymore - on wakeup, it goes right to the Today screen. I don't like it because it comes on in my pocket sometimes. I tried
HKCU\ControlPanel\KeyBd\Devicelockwhensuspended = 1
HKCU\ControlPanel\BackLight\AutoDeviceLockEnable = 1
but still no good. When I hold down the red button, it gives me a choice of Power Off, Turn Screen Off, Lock Device, and Set vibrate. If I do nothing, the screen goes off (which is where it used to be locked), but now when I hit the green button to wake it up, I see this same menu again - not the locked slider. When it goes to sleep on its own, it doesn't lock either - straight to Today screen when a button is pressed. What's going on?!?
My next attempt was to assign the "hold down red button" to \Windows\DeviceLock.exe but I can't figure out how to assign "hold red button" - what's the best way to do that?
thanks!!
Mike
Occasionally I get a problem where pressing the power button does not wake my phone up from standby, the lights behind the buttons flash and then turn off but the screen turns off. This normally fixes itself fairly quickly but it's still a pain in the mean time
I'm getting the same thing and it started today. Pressing the power button doesn't turn on the screen but the keypad lights comes on and after 10 sec it goes away and the screen remains black. Pressing and holding down the power button for 3 sec brings up the lock screen and all is back to normal....that is until the screen goes black again!
Anyone having the same problem?
This is happening after i installed chainfire's new 2.0 3d patch. I'm going to uninstall it and see if it persist.
I'm on stock TmoUS HD2.
I had this issue before. Check whether the below setting is enabled.
Start > Settings > Menu > All Settings > Today > Items
The setting "Today timeout", at the bottom left hand corner,
should not be selected/enabled.
When I receive a call and my phone is in standby mode when the screen is black, then opens it does not automatically screen, it continues to be black, I must press the Home button to make something appear. Is there a solution to this "problem"?
Anyone notice that when the phone is in your pocket (ie sensor covered), you press the power button to activate the screen, then take the phone out, the screen will shut off as soon as the phone is out?