Related
Quote this FAQ from myxda.com :
Q. Is it possible to activate the loudspeaker on my xda before choosing a telephone number? Is it possible to permanently turn the loudspeaker on loud, so i do not have to press the green button?
A. There is a way for doing this. The only disadvantage: after a soft-reset this setting is not activated anymore and must be readjusted. Dial any number, for example the Voicemail Box, so that nobody is disturbed by a phone call. Then disconnect and tip onto the signal symbol in the title bar. Tip onto the disconnect telephone button and then immediately press the green button (accept telephone call) keeping it pressed until the note appears: The loudspeaker is activated. The telephone then disconnects, without establishing a connection. The information that the loudspeaker is activated remains. The next step is turning on the telephone. The loudspeaker is turned on instantly with each dialled number. However, you can always turn the loudspeaker on or off by pressing the green button a little longer BEFORE dialling.
I've tried it and there is no response, even I can not get first step (Tip on the disconnect button ). May be this FAQ is only for XDA I ...
Has anybody tried it on an XDA II ?
Has anybody a way to permanently activate loudspeaker on XDA II ?
Yes, I've tried it, it works.
But sometimes could be difficult to activate due to some lag or slow response time for taps ... Once activated, the screen will look like this:
Can yo please explain it step by step ?
I've tried a lot of times, withou results. Thanks
ok, i found this easier:
- Turn on flight mode.
- Press green button for a few seconds until it says "Speakerphone is on". (Don't worry, as you're on flight mode, no call is made)
- Now, turn off flight mode to use the phone and have the speakerphone always on.
Enjoy.
No way !!
Turn On fligth mode.
--Press green Button while in TODAY opens Phone Screen
---Press green button while in PHONE screen shows Buuble "The phone is currently off. Dou you want to turn Wireless on?
I have ROM 1.60.00 WWE
-- Radio Version 1.10.00
You'll have to PRESS DOWN AND HOLD the green button for about 2 seconds. Not just one click.
Of course I did it
Have you been able to activate speakerphone during a call before?
The procedure is the same, press and hold down the Green button should activate, except that this is done when flightmode is on.
It's strange why your unit doesn't behave the same? Try hold down longer perhaps..
@chriswo
sorry for OT, but PLEEEEASSSE let me know the name of that software you're using for the today screen. i've been desperately looking for something like this for ages now.
thanks
regards ize|man
if you mean
chriswo's screenshot
then do you mean the signal strength
or ?
if you're talking about the launcher, it's called cLaunch, it's free.
Yes I can activate it during a call, and as I like it (it works 'sufficient' for me as a hands free for the car) is because I wanted to have it always activated.
May be there is some installed software. Will try to uninstall what is not essential. Can you post your rom & radio versions ?
boyz boyz you're fast as lightning
i just updated the screenshot. pls reload this page.
and YES it's cLaunch i just googled and it seems to be what i need (BIG buttons on the today screen)
thanks a lot
regards ize|man
Alrught, if you find it difficult to activate Speakerphone while on flight mode. try this:
On PHONE display, turn on flight mode and immediately PRESS AND HOLD DOWN the green button. Don't let it go completely on flight mode, so you got to do it while the radio was shutting down.
try that and let us know.
OK, this one WORKED without problem.
Now I have a 'perfect' and 'cheap' handsfree for my car.
THANK YOU very much !!!
Chriswo?
Where did you get that signalstrenght today plug in from ? looks really good
That's HudsonMobile PhoneDashboard.
Anyone notice if you cancel the speakerphone, then enable your bluetooth headset and make a call, the headset stays connected even after you end the call?
I don't know if this really is an advantage or not, I'll see how much more the battery drains if any.
Also, I notice that after activating the speakerphone "always-on", my ringetone gets almost silent. :?
Anyone know how to stop an accidental clicks or other screen presses from taking place when I've got the phone to my face during a call?
Si.
I use a freeware app called Screen Off, download it here:
http://www.handango.com/PlatformPro...latformId=2&N=96806&productId=125781&R=125781
Basically when I make a call or answer a call I have screen off assigned to a button, so I can then press the button to turn the screen off. To turn the screen back, just press the power on button.\
Hope this helps,
Or maybe you could simply turn PDA off with a single power button press...and when you're finished simply turn it on. Remember that the radio is always running (unless you hold the power button for 5s).
My screen turns off automatically after about 20 seconds when on a call - haven't set it to do this - in fact can't even find an option - it just seems to be the default setting. The only way to turn it back on is to press the green or red buttons, or just flick the volume control either way - works for me. (O2 XDA Mini s)
S.
Macrinus - thx that works a treat.
That's weird, your screen turning off after 20 seconds, mine turns off as configured in "Turn backlight after..." and "Turn off device...".
macrinus said:
That's weird, your screen turning off after 20 seconds, mine turns off as configured in "Turn backlight after..." and "Turn off device...".
Click to expand...
Click to collapse
Yeah, it is weird - bit annoying, but sensible really to save the power - Perhaps its just the device turning off then, with the phone still running .... comes back to life with a flick of the volume though - touching the screen won't re-activate it. Will have to time it a bit more closely !
S.
Radio on screen off
I too turn the device off when I'm on a call (although I only discovered I could without ending the call this morning). Otherwise, my ear activates the Start menu.
Doh!
if only the backlight is turned off, the screen WILL still react to face contact!
I understand that either the device (less the phone side!) via power button, or the screen must be turned off via an utility.
It may exist, but I know no proggie able to lock the touchscreen without turning it off!
(pitty, my axim X50v can lock the screen without turning it off via a Hw sliding button9
I noticed that every time my phone rings I can't get it out of the case without answering the call. I like to be able to view who is calling and decide if I want to take the call or not.
When I take it out of the case I must be hitting a button that causes it to answer. It seems like it will answer if ANY button is pressed, not just the green phone button or the left smart key.
I have my phone set to auto lock after a few minutes and the phone is actually locked when the call comes in.
How do I set my phone to only answer if I press the green phone button?
I'm running the standard AT&T ROM version 2.15.502.3 with radio ROM 1.40.30.00.
I have learned to be a bit more careful when pulling it out of the case.
Hi, everyone. My Tytn when is on a phone call, switch off the screen. I can't find anything like this in the forun (perhaps I don't look for on the right way).
I not find how to disconnect it on the configuaration of my Tytn. Does anybody knows how to get the screen on during a phone call.
The problem is when I'm driving, and on a phone call, lose the screen and my navigator instructions. It's is a problem, cause, I must to switch on the PDA and reconnect the navigator. (the people alwais call on the worst moment , I don't know why?)
Thanks to all.
Start>Settings>System>backlight>Battery Power, then take the tick off the selection "Turn off backlight if device is not used". Do the same under the external power tab.
At the bottom of the screen you should see a MENU option. Click on the Advanced tab then take the tick off the option "Turn off device if not used for ...."
This lot should solve your problem. The downside is you might then start to use more battery power as the device leaves itself in an always on position.
VCheers
WB
wacky.banana has offered some good advice. But IF your problem happens ONLY when a phone call comes in, then I think you might have phoneAlarm installed and configured to do this. pA includes this feature in order to let folks listen and speak, with the phone against their ear, and not fear starting up myriad applications as their ear touches the pressure-sensitive screen.
Just an idea.
-pvs
just press the button
just press the standby button, or any button to turn the screen back on,
id rather have the option to turn the screen back on, rather than having it on all the time especially if i am out and about, and as we all know, battery power on the tytn is a precious commodity :_)
Hi there,
I am a little ticked off with the way the phone switches the light off and you HAVE to press a button to get it back up when in the middle of a call.
Is there any way to keep the phone awake while on a call? Ofcourse, I HAVE tried out "Shake Awake", but thats a little buggy too.
And also, the buttons for Hold, Mute, Speaker mode and all those options come up only when you press the menu button. Is there any alternate dialler available or something which can get all these options on the screen while on the call like the iPhone as its easier to use it than press the button to get the options?
just install keepscreen.
edit: this will keep the screen alive. about the alternative dialer i don't know. but be aware that the phone has no proximity sensor, so you are prone to accidentally press random buttons.
Cool. Will check it out man. Thanks.
I have a different problem - since, sadly, Hero has not got a proximity sensor, I constantly drop my calls by accidently touching the end call button with my cheek. I believe that's a reason the screen backlight goes off so quickly during a call - when the screen is off, it does not react to touch too, so that accident call drops would be less likely.
There are still some serious problems though. First of all, screen timeout during a call is not short nough - while you can know that you must wait a few seconds before you can actually touch the phone with the face, others can't, so call drops are, sadly, unavoidable in such cases. The fact that hold, mute and other buttons are hidden under the menu button is a good thing not only because it keeps Android phillosophy straight, but reduces chances of unwanted misc. actions. The solution of this problem could be an option to disable the end call button, since there are dedicated hardware keys for that.
I have also noticed that if you minimize the dialer during a call with home button, the screen timeout will not be quick, so before continuing a call it's a good idea to bring the dialer back by tapping the hardware call button so the screen timeout becomes quiick again.
Very true. I thought about all these before I posted, but on the other end, I just said 'f it' to myself and asked it here.. hehe.
I wonder if iPhone users have such issues.
As someone in this forum mentioned, it is best to have the screen switched OFF during a call, unless you have something to do. This way, it prevents you from fiddling with the controls.
Not just the hero, earlier models too have this feature. It quite odd in the beginning, but you will love it later.
subhramani said:
Hi there,
And also, the buttons for Hold, Mute, Speaker mode and all those options come up only when you press the menu button.
Click to expand...
Click to collapse
Not necessary!
During a call
- Press "Call" to hold (will also mute)
- Press and hold "Call" to activate speaker mode.