Hi,
I'm using xda 2.
when I open the GPRS connection manually, it stay connected until I disconnect it.
When the connection is open automatically (when I use the internet explorer, or using any other application that use a gprs connection) the connection disconnect if I don't use the device for a minute or two.
If I continue to use the device, the connection don't disconnect.
Is there any setting that will prevent the device to disconnect.
I develop application that should synchronize to SQL server, the synchronization takes 15-30 minutes, during this time the user don't use the device...
thanks,
Ofer
Ive got the same problem.
Im using my Qtek 2020 as a Wmodem for my laptop for the moment.
If i connect, i disconnects after a few minutes and there is no speed.
But if i softreset the device and reconnect to the modem, everything works fine for a couple of hours. Then it disconnects, and i have to softreset again to make it work...
Really annoying, and took me quite a WHILE to figure out how to get it to work.
Would be very nice to know that kind of ****ed up bug this is..
Sounds like you need GPRS Tweak (freeware)
http://www.gb-soft.cz/xdaii/product_gprs_tweak_en.htm
Thanx, i think it works.. Just installed it, and put it on GPRS always ON
GPRS Tweak
I also installed GPRS Tweak but when I perform a soft-reset it don't start GPRS automaticly.
What have I done wrong?
Ger
Go to the second settings tab, there u have som settings for GPRS starting.
Although, this program didnt fix my problem. I still have to reboot everytime
i have used GPRS for 2 hours. For some reason, it resets GPRS after a random set of time... Really annoying.
Hello all,
I have a problem with my magician. When i open explorer on the unit it connects with GPRS no problem. AFter a while of inactivity, the connection is lost, so far so good. However, if i want to then surf to another page, or do anythng else that requires the connection, the unit tries to reconnect but does not. It does this over and over again until finally timing out, approximately 60 seconds.
The only way i can get it to connect again is by turning the phoen off and on again. They it connect via GPRS, until it disconnects, and the whole spiel starts from the beginning.
Any pointers on this?
Hi,
I have blackberry connect on my Qtek 9000 and it is working perfectly.
But I have 2 other connections, Internet and Work connection (2 different
apn...etc.) During day, qtek automatically (every 15-20 mins) disconnect
blackberry, connect on Internet, after 1-2 mins disconnect Internet and
connect on Blackberry.
So, how to prevent automatically connect on other APN, I want that
automatically connect works only on Blackberry. Every other connection
manually.
thanx,
best regards from Croatia
Hi,
When I am connecting Activesync with my Pc, it disconnects itself after around 15 min.
I don't know where I can change the settings to have a permanent connection when I connect my HD2 to my PC.
Thanks
Daniel
Well it started about 3 days ago.My phone can scan my WiFi connection but it cannot connect to it,if I select connect it will be connecting for a while but later will switch back to available.Sometimes it cannot even scan it,but rarely it will be connected but only stays for a few seconds.Then I realize other connection can work but only my connection will not work.Can someone explain the problem?